How to install your Unshielded RJ45 CAT.6 field termination plug for MPTL applications from Nexxt Infrastructure Lift the cap to open the plug jack. Disassemble the wire management bar from the IDC terminal. Make a circular cut 1 to 1 ½ inches from the tip of the cable and peel off the jacket. Separate the braided pairs. With a cutter plier, trim the insulating thread and the center spline. Slide wires into the management bar matching the color schemes for A and B sections. Put the assembly back on the IDC terminal and press it down until it clicks into place. Now lower the cap to close the plug jack. Press it down until it snaps. With this, you have learned how to install your Unshielded RJ45 CAT.6 field termination plug for MPTL applications from Nexxt Infrastructure
- Күн бұрын
HOW TO INSTALL YOUR UNSHIELDED RJ45 CAT.6 FIELD TERMINATION PLUG FOR MPTL APPLICATIONS
- Рет қаралды 125
Пікірлер