Great video & project... Wish you had more of the design of it. Not the 'Plans on our website' spiel.
@ToolsToday
Жыл бұрын
We understand and will try to incorporate this into future projects, thanks!
@JD-nq4vb
Жыл бұрын
I see in your videos you use a few different CNC brands. I'm curious which brand you think is the best because I am considering buying the Stepcraft M1000. I do not want to feel like I need to upgrade in 5 years so I want buy the best I can get to start with then maybe in 8-10 years I'll see where I am, but definitely want it to last 5 years minimum w/o upgrade. Curious about your opinion on all your CNC's you use. (Guitar builds mostly).
@johnolz1886
3 ай бұрын
Great video thanks but I’m curious, which font did you use and did you prep the pine 1st? I’ve never had as much luck carving pine cleanly as you appear too here. Thanks.
@amolbansode9822
Жыл бұрын
Thank you so much... 👍
@cncwoodcrafofficial
Жыл бұрын
v bit carving good job
@waynebussert5180
Жыл бұрын
I use the Oramask and the Amana RC1045 and never get a clean cut like you do. What do you do differently?
@ToolsToday
Жыл бұрын
if you could please share your feed and speed cutting parameters. thank you.
@kcoop99
Жыл бұрын
I need to clean up the edges of 1/4" acrylic, would that mini round over bit work for me?
@ToolsToday
Жыл бұрын
we recommend using either this www.toolstoday.com/v-9393-46197.html or this www.toolstoday.com/v-11748-51436.html
@amolbansode9822
Жыл бұрын
How much does this set up cost? How much is CNC machine?
@papado72
Жыл бұрын
Nice video!! What is the depth of cut for the fine text?
@ToolsToday
11 ай бұрын
Thank you! I'm not sure to be honest, it's a v-carve toolpath so it uses the dimensions of the bit and the size of the design to figure out how deep it needs to go to make it.
@papado72
11 ай бұрын
@@ToolsToday I got it...thank you. 90 degree bit?
@ToolsToday
11 ай бұрын
Correct
@matthewransom6469
Жыл бұрын
I need to flatten a small table I have done. I'm using a router sled not a cnc. Is the amana rc-2255 a good bit that you would recommend for that. On a router sled??
@ToolsToday
Жыл бұрын
Yes, it will work great for a router sled!
@matthewransom6469
Жыл бұрын
@@ToolsToday ok thank you very much for your reply. I'll be ordering one tomorrow then. Now the ToolsToday website that I can order from is that your website? I am because I'd like to order some replacement blades for it as well and figured you could direct me on that as well. If you don't mind
@ToolsToday
Жыл бұрын
Sorry, totally missed this. Here is the replacement blades for it - www.toolstoday.com/v-13333-rck-457.html
Пікірлер: 21