Absolutely love your channel! It’s down to earth and shows what a real wood shop looks like when working…. Great tutorial! Thanks for sharing Jeff.
@bradleytuckwell4881
Ай бұрын
Brilliant tutorial thanks
@bartholomewgreatpants3425
Ай бұрын
This is a good video. You need more attention to your channel. That was a hell of an explanation
@pknepper44
Ай бұрын
You did not do a drawbore to pull the breadboard tight as most do. Do you not find it is needed?
@JeffDevlinOfficial
11 күн бұрын
For large pieces yes I would offset the hole and pull it tighter however in my experience if it is too tight the finish will lock the breadboard to the table thus not allowing for movement. Please note I would still make sure that the joint is tight before drilling any holes. If you wish to offset the holes just make sure to allow the dominoes to dry in place before trying to draw bore.
Пікірлер: 5