This is how I made my charging station for my four different electric screwdrivers and drills. This is one thing everyone should have in their garage / workspace. It is wonderful to always have one machine or battery fully charged when another is out of power.
Even if you only have one machine, you can easily make an equally large charging station, as you quickly get other things you can integrate. If you need more space, just use this as inspiration for how you can make it, just keep in mind that the shelves I have made for battery and chargers work well in this size, but if you make it larger, you will probably have to use a thicker plywood board than the one of 6 mm that I used here.
COPING SAW
To cut out the drills and batteries, I used a coping saw. This is a saw that you can easily saw in several directions, which makes it a good alternative to a jigsaw. It also did not take much longer to saw with a coping saw than a jigsaw.
Is this a tool you could imagine, then I have added a link to one you can buy cheaply in the list further down.
CUT LIST
These are the sizes I used, as mentioned earlier you can use this as inspiration and make it bigger if needed, but consider a thicker plywood for battery and charger shelves if you make it bigger.
½” / 15mm Plywood
2 x 270mm x 320mm (10,62 x 12,59)
1 x 270mm x 410mm (10,62 x 16,14)
1/4” / 6mm Plywood
2 x 270mm x 390mm (10,62 x 15,35)
1 x 100mm x 390mm (3,93 x 15,35)
1”x2” / 24x48mm
2 x 410mm (16,14 inches)
OTHER THINGS YOU NEED
Wood Glue
16 screws
Tools i did use
B+D table saw
Table saw sled (Se hvordan jeg laget den her • How to make table saw ... )
Drill
Coping saw ( You can find one here lite.al/O1WE-v )
Jigsaw
I have plans for expanding the charging station, both to accommodate more tools but also to get more things charged. Follow my channel to see what changes I make over time.
I will release new videos about once a week, a lot of exciting things to come, so stay tuned.
Негізгі бет How to make a charging station for your tools in the garage
No video
Пікірлер