Derinkuyu Submersible Pump Panel Installation Liquid Level Relay and Floater Connection How to Install Float.
At the same time, I connected a liquid level relay to the submersible pump and also made a floater connection. As long as there is water in the well, the submersible pump will operate and the float will be active as long as the motor does not draw high amps and discharge thermal power. If the tank is full, it will open the circuit by pressing the switch with the marble in the floater and cut the energy going to the a1 phase coil leg of the contactor. And naturally the closed contacts of the contactor will open and the motor will stop.
I both explained with the start stop connection and made the connection by canceling the control circuit.
When the start stop connection is canceled, you need to get the energy to the common end of the float from the 96 NC contact of the thermal, naturally you have to give the 95 NC contact neutral. Otherwise, the thermal will not work.
"How to Connect Deep Well Submersible Pump Liquid Level Relay and Floater"
floater,
#diver
liquid level,
Негізгі бет How to make a deep well submersible pump liquid level relay and floater connection.
No video
Пікірлер: 259