Today is day two of our DIY Laser Engraver build. In this video we will install the electronics of our laser engraver. Many of the parts are 3D Printed and will require a 3D Printer. We will cover many topics in here for new Laser users including Laser Safety, Focusing the Laser and what you can cut or engrave with a laser safely.
WARNING: Lasers can be very dangerous and extreme caution should be exercised when attempting to build this project. Understand the risks to you and others by building a project like this.
Buy Quality Laser Eye Protection, see what @styropyro says about safety glasses - • Video
docs.google.com/spreadsheets/...
Link to models on Thangs:
social.thangs.com/m/54323
Firmware Repo: bitbucket.org/makersmashup/wo...
0:00 - Introduction & Features
4:23 - Laser Safety & Safety Features
9:21 - Laser Build Electronics
15:38 - Marlin Setup
16:12 - Materials
18:54 - Lightburn Setup
20:22 - Laser Focusing
23:25 - Laser Testing
24:00 - Laser Wrapup
Please mash that like button if you enjoyed this video and leave your comments below!
Please consider helping support the channel through Patreon so I can continue to develop new content.
/ makersmashup
Chat with us and other makers on our Discord: / discord
Follow us on Twitter: / makersmashup
Instagram: / makers_mashup
Visit our website www.MakersMashup.com
MakersMashup Uses TubeBuddy as their KZitem assistant! www.tubebuddy.com/MakersMashup
Негізгі бет Ғылым және технология How to make a DIY Laser Engraver - CoreXY | Part 2 - Electronics
Пікірлер: 114