Good job. I don’t need another router bit to make a gnocchi board. Darlington, South Carolina
@GlennFrazeeYT
3 жыл бұрын
Thanks William. I'm in the process of making a batch using a V-cut bit, video will be out soon.
@williamlott7612
3 жыл бұрын
@@GlennFrazeeYT I stopped by Home Depot this morning and picked up some oak to give your method a try. After I got the saw height set, figured out the fence incremental movement, and tested it on some scrap, I proceeded with the oak. The cuts were clean and the ridges and valleys sharp. I am very pleased with the results and am looking forward to making some gnochetti pasta with it. Thanks again; appreciate your efforts. Darlington, South Carolina
@AA21CHILE
3 жыл бұрын
Magnificent! 👏👏👏👏👏👏👏👏👏👏
@GlennFrazeeYT
3 жыл бұрын
Thanks! 🙂
@ysfrs42
Жыл бұрын
Please How much space between each line
@GlennFrazeeYT
Жыл бұрын
Depends on the depth of cut
@rayorosz4350
3 жыл бұрын
Hi Glenn. Beautiful work! Do you sell them?
@GlennFrazeeYT
3 жыл бұрын
You're in luck, I have one left! www.glennfrazee.com/store/p/gnocchi-paddle
@rayorosz4350
3 жыл бұрын
@@GlennFrazeeYT Thanks Glenn. Too rich for my blood. I will keep admiring the craftsmanship though. Wished I could afford it in my budget.
@philparrish8892
2 жыл бұрын
Have you never heard of push sticks? better than losing fingers.
@GlennFrazeeYT
2 жыл бұрын
Sure have.
@g.r.4853
4 жыл бұрын
So educational!! I never knew how to adjust my saw, glue and clamp or cut grooves with my fingers just above the spinning blade. The why's and reasons were a crystal clear as air. Wonderful presentation of see what I can do, you don't need to know that crap!
Пікірлер: 17