Here I'll show you how to make your own high powered USB charger.
It can charge up to 4 devices at over 2 amps each at the SAME TIME!
Perfect for running your Raspberry Pi, phone, tablet, etc.
Here's the parts list:
- IEC socket, fused type. (Or a separate fuse holder if you use an unfused socket).
- Mains rated power switch.
- Miscellaneous resistors.
- Screws and standoffs.
- Wire, thick enough for the high current. I used 0.75mm2
- LED's of your choice in colour.
- 2 amp - 2.5 amp polyfuses.
- Switched USB hub.
- 5 volt, 10 amp power supply unit (open frame or closed frame style).
- Enclosure large enough to house your PSU and USB hub.
Patreon link: / nfm
Негізгі бет Тәжірибелік нұсқаулар және стиль How to Make a High Power USB Charger
Пікірлер: 64