How to make A Low Cost 3D Printer. Part 2
Made by :-
Shaikh Mohammed Adil
Abdur Rehman Chhapra
Shaikh Junaid
Khan Nehal
3D pen used in this printer is of low cost so that the overall budget of the project is reduced. Other than that, few small electronics are also needed to make the switch automatic.
1. 3D Printing Pen
2. 22k Ohm Resistor (value may vary depending on the type of 3D pen)
3. 1k Ohm Resistor (for testing)
4. NPN Transistor ( 2N3904)
5. Wires
In this video we are showing how to hack the 3D pen for printer applications.
Please do Like 👍 , Share ⤴ and Subscribe ▶
3D Pen Connection
drive.google.c...
Негізгі бет How to make A Low Cost 3D Printer. Part 2
Пікірлер