Make long coils of jump rings with this DIY jig. Using just plywood, bolts, bearings, and your drill amaze your friends with all the coils.
Plans: www.builditmakeit.com/store/p...
or: builditmakeit.etsy.com
MATERIALS
18mm or 3/4” plywood
608 skate bearings: geni.us/mrmCp6o (Amazon)
1m or 3’ steel rod (can accommodate 1.3m and 4’ as well)
Hardwood or plywood ~50mm/2” x 110mm/5” x 12mm/1⁄2”
5/16-18 x 1” Hex Cap Screws: geni.us/rwvHz (Amazon)
Washers (Max OD 17mm or 11⁄16”): geni.us/ezqrfih (Amazon)
Wood glue: geni.us/rTTXfxa (Amazon)
2” Screws: geni.us/W8nOs (Amazon)
1” Screws: geni.us/6u9TZO (Amazon)
OPTIONAL
Pocket Hole Jig and Screws: geni.us/3fZakuw (Amazon)
Foot Speed Controller: geni.us/xZwavr (Amazon)
V-groove Bearings (need shims or larger bolt as well): geni.us/LNXZQ (Amazon)
RECOMMENDED TOOLS
Table saw (or a band saw)
Drill
Counter Sink Bit
Circle Maker: geni.us/MVdsyi (Amazon)
OPTIONAL
5/16-18 tap: geni.us/LtByy (Amazon)
Band Saw or Jig saw or hand saw
Brad nailer (or hammer and finish nails)
Build It Make It Links:
----------------------------------------------------
Website: builditmakeit.com
Etsy Shop: etsy.com/shop/BuildItMakeIt
Instagram: / builditmakeit
Thingiverse: www.thingiverse.com/builditma...
Thanks for the music from StreamBeats check them out - / @streambeatsbyharrishe...
Links may be affiliate thinks.
Chapters:
0:00 Intro
0:21 Materials
0:45 Plywood Cuts
1:45 Drill Carriage
3:28 Base
3:47 Bushing Holder
4:25 Mounting the Drill
5:56 Bushing
6:39 V-groove
7:17 Steel Rods
7:44 Speed Control
8:18 Winding
9:10 Outtakes
#chainmail #woodworking #armor
Негізгі бет Тәжірибелік нұсқаулар және стиль How to Make a Super FAST Jump Ring Winder for Chain Mail, Jewelry, and more! | Plans Available
Пікірлер: 27