This showcases the necessary steps, from beginning to end, to make a very simple beginner friendly wooden crankbait.
Every Single Material I used:
Desk
Bandsaw
Electric drill
1/4" drill bit
Power 6" disk 1" belt sander combo
Flush cut saw
100 grit sandpaper
220 grit sandpaper
4" vise
Vise pliers
Needle nose pliers
Stainless steel safety lock wire
Starbond liquid CA glue aka LIQUID super glue (NEEDS to be LIQUID to work)
Baking Soda
1/4 ounce Lead egg sinker
Lexan polycarbonate
Regular ole printer paper
Scissors
Glue stick
#2 HB pencil
Speed square
Glass Cabochons
Bass wood
Polyurethane
Air brush
Air brush paint
Window Screen
Large clip
60 lb split rings
#1 treble hooks
East Coast Resin epoxy
Music:
Tuba Waddle by Audionautix is licensed under a Creative Commons Attribution 4.0 license. creativecommons.org/licenses/...
Artist: audionautix.com/
Panama Hat by Audionautix is licensed under a Creative Commons Attribution 4.0 license. creativecommons.org/licenses/...
Artist: audionautix.com/
If you have any questions I will be happy to answer any of the comments
Негізгі бет How to make a Wooden Fishing Lure Start to Finish
Пікірлер: 12