I learn something new with every video you post. I appreciate the great info
@JackArmstrong-jackdaddycustoms
Жыл бұрын
Thanks brother
@Jurry623
Жыл бұрын
You make awesome videos sir
@JackArmstrong-jackdaddycustoms
Жыл бұрын
Thank you
@_bilski
Жыл бұрын
Where'd you get the rubber bungees for this?
@JackArmstrong-jackdaddycustoms
Жыл бұрын
Amazon
@tristonbowen9923
Жыл бұрын
So I made a h weight mold with Bondo and after 3 pores it failed any tips
@JackArmstrong-jackdaddycustoms
Жыл бұрын
I hate to hear that. I wander if it cured too fast, maybe too much hardener in your mix. If not, maybe slow down on the time in between pours.Mine definitely “age” so to speak, but I have over 50 pours on it and I could use them some more.
@tristonbowen9923
Жыл бұрын
@@JackArmstrong-jackdaddycustoms how long do you wait between pouring again?
@JackArmstrong-jackdaddycustoms
Жыл бұрын
@@tristonbowen9923 as soon as it flashed I would dump it, then I waited maybe 2-3 minutes before pouring again.
@tristonbowen9923
Жыл бұрын
@@JackArmstrong-jackdaddycustoms I waited like 10min
@JackArmstrong-jackdaddycustoms
Жыл бұрын
@@tristonbowen9923 I wander if it cooled too much and the cooling and heating contracting and expanding caused it to fail to early. Maybe try speeding up the pours???
Пікірлер: 14