Hey Team! Would you rather roll or spray ceilings? I placed timestamps below to help you navigate this video. Enjoy! Painting supplies 00:21 How to paint a ceiling using a roller 02:17 How to paint a ceiling using a sprayer 05:11
@jaeayala8616
2 жыл бұрын
Spraying gets u a better finish
@charlesviner1565
2 жыл бұрын
I like watching your videos because they are all about building your own house and saving a ton of money 💰 👍
@TheExcellentLaborer
2 жыл бұрын
Its all about building a better tomorrow. Thanks for the comment Charles!
@T.E.P..
2 жыл бұрын
This is how it's done and you know. How you do it all yourself is a mystery ... must have a strong family loving you and excited for you and supporting you. All the best man!!! great great great
@TheExcellentLaborer
2 жыл бұрын
Hey Thor! I do have a great family to deal with. After working most of the day there is nothing better than spending time with them. Of course it’s always an obstacle juggling work and life. Thanks a lot for watching!
@davidregan9872
2 жыл бұрын
Flat paint is very forgiving when it comes to flashing. When we use anything with a gloss on a ceiling we roll from one end to the other. I like to have my roller loaded up with paint before I start rolling. I started out using a 9 inch roller years ago, and still do. You can use a small 4 inch roller instead of a brush for the edges if you want. We would thin our paint a little if it covered good with one coat! I've painted for over 35 years, and thinning really helps with heavy textured walls, and ceilings. Nice job! I wish I was there to help! LOL
@TheExcellentLaborer
2 жыл бұрын
Sounds like you have a lot of experience David! Yeah nothing wrong with using a 9 inch roller. Whatever works for you is what works! Thanks a lot for watching!
@davidregan9872
2 жыл бұрын
@@TheExcellentLaborer Thanks for the reply! I really wish we had them years ago. It would of saved a lot of time, and time is money! They are a pain to clean though! My old boss who died last year used to say, " Put it on heavy! Paint is cheap!" A few years later he told me, "Paint is expensive!" LOL
@kidjetrecon7153
7 ай бұрын
Sprayed for a few years love your spray roller technique. Going to try, all new construction. ❤
@sarahmiller544
2 жыл бұрын
I’m a new to your channel and new-ish painter/contractor. I just purchased the same sprayer last week and I referred to your videos to help understand it. It was super helpful!
@TheExcellentLaborer
2 жыл бұрын
Hey Sarah! I’m glad I could help. So far it has been a great sprayer. Good luck with your business!
@robertc.6441
Жыл бұрын
Very informative! Straight to the point, with great step by step instructions. I also agree that unless you are going to be doing alot of painting the roller and cutting brush process is the more budget friendly way to go and will get it done! Don't forget the plastic and frog tape! Ribbit Ribbit!
@ckuiper7332
2 жыл бұрын
Awesome video (as always!) -- I can see how spraying a ceiling is a lot quicker with less steps. With my particular applications (mostly re-paint and not new construction) I can't go there as mush as I'd like! I completely agree on the two coats plus primer - "it's never a crime to prime!" - and two primer coats never hurts, especially with a once over sanding between! which by far makes the end result awesome! compared to: 'ok - it's done.' In rolling, namely with the 9" rollers, I've always painted two directions - perpendicular to each other while "feathering to carry the wet line." The larger roller and tray is certainly the way to go! Regardless, it's a challenge on the larger open areas of higher ceilings with higher temperatures and faster dry times at the ceiling level; so yeah two coats are always a must. We can also see it's also very true with the "paint toward the light" direction you provided here. Oh Yeah - and the back roll suggestion after spraying is extremely insightful with respect to any further required work -- Si Muy Bueno Mystro!!! 😎
@TheExcellentLaborer
2 жыл бұрын
"it's never a crime to prime!" I love this! Yes back rolling takes more time but a much better job is achieved. Sounds like you have a lot of experience with painting. Your input is always welcomed and appreciated. Thanks C Kuiper!
@ryanmont7119
2 жыл бұрын
walking while your spraying ceilings is for amatures... you dont trust your overlap or dont know how...
@ckuiper7332
2 жыл бұрын
@@TheExcellentLaborer yep,. boat loads of "practice" with the A-Z
@michaelc.ateoate979
2 жыл бұрын
ceiling specific inline handle is nice if you do a lot of ceilings less fatigue on the user I love mine
@howardmullings7047
2 жыл бұрын
Very good just learned something new about spraying thank you
@TheExcellentLaborer
2 жыл бұрын
Thanks a lot Howard! I appreciate you coming on my video. Stay tuned for more!
@seanmiller7298
Жыл бұрын
ive sprayed and rolled on a sante fe knock down. Sprayed a ceiling and all walls...no roller at all. amazing coverage. Roller alone actually left more small spots that paint didnt get into. Spray was best 100% Also did cieiling with no cutting. overlap onto walls. The tape with paper the ceiling edge. Work down. Very easy and half the time of rolling
@Mowers11
2 жыл бұрын
If you use S-W CHB ceiling paint you do not have to back roll the ceiling. Also that tip can leave tracks. Use a green fflp 616 and you are good to go. Done 2-3 hundred this way last 4 years. That ceiling wold be 19 minutes this way.
@AlexKunstar
2 жыл бұрын
I stopped back rolling ceilings years ago as well, completely unnecessary with good paint and proper technique and the right tip. CHB sprays nice, and eminence sprays even nicer (and a brighter white). The 616fflp tip is great, even use my 514fflp and 516fflp at times, just depends on which one is cleaner lol. I've knocked out massive 8car garages with 14' ceilings+walls with that setup in 2-3 hours before, from bare drywall to flawless double sprayed nice and heavy. Looked absolutely perfect from every angle.
@TheExcellentLaborer
2 жыл бұрын
Very interesting. I’ll have to give it a shot on the next house. I appreciate you watching Brian!
@ricosrealm
9 ай бұрын
Perfect. I've done a a few ceilings and got a green 617 tip to spray with low pressure and less overspray. When I sprayed a quality sealer (acrylic resin, not pva) on as a first coat, I noticed my next coats were very smooth... not using a good sealer caused the primer/paint to look uneven as well.
@jaeayala8616
2 жыл бұрын
I use a 4 foot extension pole with a swivel and a 625 tip. 515s are used for trim for smooth finish, but I do production work. Back rolling should not be necessary spraying ceilings though to prevent from having roll marks. Cris cross your sprayed ceilings and fog more than actually spraying it at close range.
@Joanzak52
2 жыл бұрын
You convinced me to roll paint my ceiling
@Anonymous-mz4fn
Жыл бұрын
fews days back I used the roller on ceiling. Just make sure you wear throwable cloths and googles as paint falls down like spray while rolling.
@brianransom4778
6 ай бұрын
Questions! I have a whole new build house (mine) to prime and paint. With the primer, is there any need to back roll since there will be finish coats? Is there a reason to back roll the first finish coat or can I save time and only back roll the second finish coat?
@christophermaguregui5736
3 ай бұрын
Hello would you still back roll a popcorn ceiling after spraying it and I’m assuming you put paint on the roll?
@allendelisle8145
2 жыл бұрын
Now after you sprayed that ceiling are you also spraying the walls or rolling it if it's the same color????
@TheExcellentLaborer
2 жыл бұрын
I always do the walls and ceiling separate. I’ll always start out at the ceiling and do the wall second. Hope that helps!
@jasonhutchinson3797
Жыл бұрын
Hey There. I know this is for the purposes of presentation but would you still be moving at a pace where you'd be aiming for keeping wet edges?
@TheExcellentLaborer
Жыл бұрын
Yes keeping the edge wet is important. Hope that helps!
@ben3462
2 жыл бұрын
What if theres windows on 2 sides of house 🤔🤷♂️
@shevinsacrey5862
2 жыл бұрын
If you know you will be painting the walls, something you can do is mask around the perimeter of the wall where it meets the ceiling with the paper on your masker, or use the plastic sheeting if you want to completely cover the walls, up to you. And then you can use a regular roller to cut in, just shove it right into the corner and make sure the paint gets right in there. Saves you from having to go around with the brush. If I were doing a room like this that's what I would do. If you're back rolling I don't really see the point of using the sprayer, unless maybe you had two guys, one spraying and one back rolling. If it's just you then why spray and back roll. Just roll it.
@asphyxiator5247
2 жыл бұрын
Use a mini roller:whiz roller for perimeter cut ins. You risk damaging the wall with the end of the cage running it the way you suggested. Most of the time you’re fine but why risk it when a whiz roller is faster than trying to ensure the 9” gets the angle
@shevinsacrey5862
2 жыл бұрын
@@asphyxiator5247 I meant to add that, use the whiz roller if you want as well. I've never had a problem with it though, I've never damaged any walls and I've done hundreds, you don't have to press it that hard to get in there. Plus you avoid having to use two separate containers and clean both. Nothing wrong with the whiz though. I've done it before it just takes a bit more time. Also if there is areas where the 9 doesn't fit I'll use it.
@Midwestplayers
2 жыл бұрын
Do I prime the ceiling first before painting?
@TheExcellentLaborer
2 жыл бұрын
Yes it’s always best to prime. I hope that helps!
@janser305
2 жыл бұрын
what if there are two windows and a sliding glass door where sunlight enters all of them?
@terrythomas790
2 жыл бұрын
Do you to use more paint spraying vs rolling?
@TheExcellentLaborer
2 жыл бұрын
I would say spraying uses more. I hope helps!
@ricosrealm
9 ай бұрын
they can be equal, but you end up losing more when you have to clean the sprayer or if you calibrate the sprayer higher than needed.
@eddieadams4770
2 жыл бұрын
Nice video!
@TheExcellentLaborer
2 жыл бұрын
Thank you Eddie!
@allthewayinu
2 жыл бұрын
I prefer1/2" to 3/4" nap on my 18's
@ryanmont7119
2 жыл бұрын
all depends on texture...
@francisnglam7083
2 жыл бұрын
I prefer roller than spray too much overspray dust everywhere etc
@1imanni1
11 ай бұрын
If you got to spray and then roll you might as well just roll.
@stevenhedges7555
2 жыл бұрын
Walk straight into the room on a morning from scratch roller wins Fact
@charlesviner1565
6 ай бұрын
👍🔨
@TheExcellentLaborer
6 ай бұрын
Thanks Charles!
@brianturner8325
9 ай бұрын
I might just wash my liners 😝
@tedmcdonald3377
2 жыл бұрын
😎🛠️😎🛠️😎
@TheExcellentLaborer
2 жыл бұрын
Thanks Ted!
@antennawilde
Жыл бұрын
No concern on back-brushing the corners? Not in love with the idea of spraying without back-brushing, at least for the first coat. Man, you need another guy. I hate having to put the sprayer down and pick up the roller all the time, so much faster with two people. Also if you spray the ceilings thick and make sure the back-rolling evens things out, you can get away with one coat.
@danp6346
2 жыл бұрын
Why 3/8 nap
@TheExcellentLaborer
2 жыл бұрын
I always use 3/8 nap for all my finish coats. Just my preference. Thanks for watching!
@ckuiper7332
2 жыл бұрын
@@TheExcellentLaborer it takes a lot less of a gulp of paint to fill the roller; it's easier to clean - AND - it gits the job dunn! 😎
@danuwbroto5756
11 ай бұрын
Like
@truckloadofrhymes1
2 жыл бұрын
If you know how to use a gun spraying is always faster cuz you only have to do one coat
@manuelkorivu3966
10 ай бұрын
But masking time take longer
@yovanyarroyo3110
2 жыл бұрын
Too slow
@chadcollins8892
2 жыл бұрын
To big of a tip to be using...to much wasted paint ....
Пікірлер: 66