When building a subwoofer enclosure you can improve the sound by using a double baffle. This can be done by laminating to pieces of material together. But there are some common pitfalls. In this video I how you how to perfectly line up the two pieces when creating a double baffle for your subwoofer.
If you would like free access to drawings and the cut list for this build just send and an e-mail to diyaudioguy@gmail.com with the word "birch" in the subject line.
If you found this video helpful then you can support the channel on Patreon for as little as $3 a month: / diyaudioguy
Or you can help out with a one time donation: paypal.me/diyaudioguy
Affiliate* links to products used in the video
Glue Spreader: amzn.to/2LfxjAB
Parallel Clamps: amzn.to/3neVa0E
Bar Clamps: amzn.to/3n3Sdj7
Wood Glue: amzn.to/3oasuXE
Cordless Brad Nailer: amzn.to/3ocQR79
Ports: bit.ly/34iLI5H
Connect with me on social media:
Facebook: / diy-audio-guy-11142806...
Instagram: / diyaudioguy
Blog: www.diysubwoofer.net
Twitter: / diyaudioguy1
Chapters
0:00 Introduction
0:35 Fail!
1:22 Trick #1, Flush Trim
1:32 Trick #2, Table Saw Trim
2:35 Trick #3, Salt
3:18 Trick #4, Clamps
4:15 Sound Advice
4:45: Success!
*As an amazon associate marketer I may earn a small commission on qualified purchases. As an affiliate marketer I may earn a small commission when you make a purchase at parts express.
Негізгі бет Тәжірибелік нұсқаулар және стиль How to perfectly align a double-baffle!
Пікірлер: 39