Thanks, good video... Do I remove the wire that's in the com slot that has a resister on it when I put in the jumper?
@JasonTech
23 күн бұрын
Q. Do all your zones have resister on them?
@bobicard2503
22 күн бұрын
@@JasonTech Yep...
@bobicard2503
22 күн бұрын
every com slot has a resister, but not every zone has a com slot...
@JasonTech
20 күн бұрын
Put the other end of the resister in the zone.
@bobicard2503
20 күн бұрын
@@JasonTech So, I should snip the resister wire that is attached to the com wire and put the sniped end into the zone slot? Correct?
@TheHowieM
7 ай бұрын
If I don’t know what zones are connected to the doors and windows, how can I find the zone number corresponding to each location?
@JasonTech
7 ай бұрын
Have someone open a zone (door/window) and a 2nd person to check the keypad. 2nd way is to tone out the wires.
@TheHowieM
7 ай бұрын
@@JasonTech Hey Jason. Thanks for the quick response. I did try that, opening the front door next to the device. It displays "Front Door," but not a number. I'm trying to find the number. Then I realized the zones are displayed in order. So I can get the numbers now by counting as I scroll through the zones.
@JasonTech
7 ай бұрын
What keypad model do you have?
@TheHowieM
7 ай бұрын
@@JasonTech 9057. I figured out the zone numbers by going to the bypass menu and scrolling through the locations. So I'm all set! Thanks.
@Mr.ShotTV
4 ай бұрын
How to you rearm a permanently bypassed zone?
@JasonTech
4 ай бұрын
You can't, you will have to bypass then arm each time. The best thing to do is to remove the zone if you don't need it.
@raj-qc8xv
7 ай бұрын
Hi bro we have two zones error change pir but arming pad in issue same pls give suggestion
@JasonTech
7 ай бұрын
You changed the motion? Do the motions light up? Do you have EOL?
@dudleycrotz7374
7 ай бұрын
I have zone 1 as the entry door to our church and in the entry area facing the door a zone 2 PIR. I programmed section 1 with an entry delay of 30 seconds, the middle delay 90s and the exit delay 45s. Here is the challenge. When arming and disarming with the remote control there is no alarm when entering. However if I don’t use the remote, both zone 1 and zone 2 sets off the alarm when entering as if there is no delay programmed. Any assistance will be appreciated as the armed response keep calling when people with access codes enter and the alarm is triggered on entrance. Thanks
@rachelelsner5195
2 ай бұрын
Is the installer code the same as the master code?
Пікірлер: 23