The fan duct should be printed the way the STL file is oriented. The vertical part will print fine. 🍍
@LiquidSSSnake
Жыл бұрын
@@Pineapple22 Thanks, I thought so. I had to slow the speed from the default 50mms to 30mms and it printed fine the third time in PLA.
@Duewester
2 жыл бұрын
BAM! That 4mm hole and extending my tube all the way to the dual gears was THE THING that did it for me. I had already done all the other things. Thank you for sharing this.
@kiksu1
3 жыл бұрын
I bought Ender3 V2 and changed just the bowden tube to Capricorn XS with 1,9mm inside diameter and Recreus Filaflex TPE 82A printed nicely when I tested it.
@Pineapple22
3 жыл бұрын
Glad the Tube did the trick for your printing needs. Thanks for Watching 🍍
Пікірлер: 7