CAME TOP 432EE REMOTE, CODING INSTRUCTIONS
CODING YOUR NEW REMOTE
During the coding process, if you press one of the buttons of the already
programmed remote control first, you run the risk of erasing the codes of all
of the remote controls that have already been programmed
1. Press both top buttons on your new remote control at the same time.
Keep them pressed down. The LED light on your new remote control blinks
slowly and then faster. Let the buttons go.
2. Press the button of your new remote control. Let it go. The LED light on your new remote control remains lit
constantly.
3. Place an already-programmed remote control next to the new remote control so they touch as shown in the
diagram above. While the light on your new remote control is lit constantly (5 seconds only), press the same button
on the old remote control that you pressed on the new remote control until the LED light on the new remote control
blinks three times.
4. Your new remote control is programmed. Repeat the procedure for each button you wish to program.
CODING DIRECT TO RECEIVER
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the button CH1.
3. While keeping the button CH1 pressed down, press the first button on your new remote control. Let the buttons
go.
4. On the receiver circuit board, press the button CH2.
5. While keeping the button CH2 pressed down, press the second button on your new remote control. Let the
buttons go.
6. Your new remote control is programmed.
Негізгі бет How to Programming CAME 432 EE | How to duplicate a CAME transmitter | Top 432 EE
No video
Пікірлер