I'm re-gearing my Dana 44 on my 1974 Ford Bronco. I took the axle to the guys at Tennessee Classic Trucks, since they already had the tools needed to do the job. This Dana 44 is for my Bronco Restoration project, but will work on any Dana 44 for a jeep.
Tools Needed:
- Axle bearing puller $700 - amzn.to/3xiAYBK
- Drive Beam Torque Wrench $25 - amzn.to/39u3B7b
- Magnetic Dial Indicator $50 - amzn.to/3tBxNnN
- Shop Press $250 - amzn.to/3HkOBoJ
- Inner Axle Seal Installer: amzn.to/3Iqqzt5
- Bearing Race Driver $50 - amzn.to/3mELYop
- Differential Housing spreader $150 - amzn.to/3Ofs3YD
- Impact Driver $300 - amzn.to/3aTOdBE
- Impact Socket set $50 - amzn.to/3HydrBT
00:00 - Introduction
01:40 - Tools needed for Dana 44 ring and pinion
02:40 - Removing Dana 44 carrier
02:55 - Removing Dana 44 carrier bearings
03:12 - Removing Ring Gear
04:27 - Heat new ring gear to fit on carrier
04:47 - Install Ring Gear on carrier
05:43 - Install bearing on pinion
06:12 - Install race in Dana 44
06:50 - Insert Pinion into Dana 44
07:09 - Measure pinion bearing preload
07:50 - Install bearing on carrier housing
08:12 - Insert Carrier housing into Dana 44
08:27 - Measure backlash
09:07 - Read gear pattern
10:16 - Final assembly
Dana 44 parts
Ring and Pinion: bit.ly/D44RingPinion
Install Kit: bit.ly/D44InstallKit
Pinion Yoke: bit.ly/D44PinionYoke
Axle Shafts: bit.ly/D44Axle
*I re-used my Dana 44 carrier*
Thanks for watching and be sure to SUBSCRIBE so you'll have more Early Bronco video's in your inbox! 📬
👕 10% Off Shirts! Use promo code: KZitem bit.ly/NashEB 👕
🛠 Here are some of my favorite tools 🛠
www.amazon.com/shop/nashville...
👉🏼 My steering wheel 👉🏼 amzn.to/2NNX4on
➡️ www.nashvilleearlybronco.com ⬅️
🎥 SUBSCRIBE: bit.ly/2l5gZA0
📷 INSTAGRAM: bit.ly/NEBInstagram
💻 FACEBOOK: bit.ly/NEBroncoFacebook
#earlybronco #classicbronco #fordbronco
Негізгі бет Автокөліктер мен көлік құралдары How to Re-Gear a Dana 44
Пікірлер: 19