Nice video man, I'm also installing my AEM fuel rail as well soon 🔥👍🏼. After installing it did you start the car and drive it with the stock fuel pressure regulator? Or did you wait till you installed the new fuel pressure regulator? I'm asking because I only have a stock one at the moment
@JarrodWillemse
2 жыл бұрын
Noice! I just used the stock regulator that is fine first. I just wanted the flexibility to adjust pressure and also replace a part that may fail. It also looks nice on a new rail!
@jhonsalinas2283
5 ай бұрын
Hi mate u dont use fuel damper pulsation anymore when u put aftermarket rails???
@JarrodWillemse
5 ай бұрын
Nahh you don't have to. I haven't used them in any of my other build and they were fine.
@hks071
2 жыл бұрын
Where did you get the 90deg elbow for the fuel pressure gauge
@JarrodWillemse
2 жыл бұрын
EBay mate
@vorn7175
2 жыл бұрын
Hi Jarrod What size AN fittings that goes from the fuel rail to the gfb fuel gauge? I've got the same set up as you ☺️
@JarrodWillemse
2 жыл бұрын
1/8 NPT 90 deg male to female
@JarrodWillemse
2 жыл бұрын
www.ebay.com.au/itm/173303211940
@hobonatilife9357
2 жыл бұрын
Could you post a list of the build.
@JarrodWillemse
2 жыл бұрын
I plan to make a full video soon going over the car.
@liwaywaysellars4404
3 жыл бұрын
Was that an original AEM fuel rail or an Ali Express one
@JarrodWillemse
3 жыл бұрын
eBay haha. From what I can see it works fine. The plugs and seals were good. I paid $60.
How is your fuel pressure gauge holding up? I have destroyed 2 Grams liquid filled gauges in 2 months. Not really sure of the cause..
@JarrodWillemse
3 жыл бұрын
Mine is fine but i haven' really driven it. Make sure you get a proper one and not china. What fuel are you using?
@DAAN_MUSIC
3 жыл бұрын
@@JarrodWillemse I daily the car. But the gauges I used were both original Grams Fuel pressure gauges, purchased at a official distributor. I use EURO95 E10. It might be the quality of the gauges or harshness of my motor mounts. They literally vibrate to pieces, looking like the were hit with a rubber mallet. 😂 What gauge do you use?
@JarrodWillemse
3 жыл бұрын
@@DAAN_MUSIC I'm using a GFB gauge which is an Australian company. I Paid $40.
Пікірлер: 25