Hi, Great video and thanks a lot. Would you please make a video how to replace the front door and paper tray 1 on the same model. appreciated.
@parmjitaujla4545
Жыл бұрын
I have problem of frequent paper jam in rear panel in my HP color laser jet 2320MFP printer How I can fix it. PSAujla
@mohammadridwan8012
Жыл бұрын
manual tray 1 can't work. how to fix it
@PaulPaid
3 жыл бұрын
How often would this be required?
@alexpaul4769
3 жыл бұрын
Hello Sir. I replaced all these parts myself. I thought this would fix an issue where the paper shows pressed in marks on the paper down the middle of the paper. Any thoughts? I wish I could send a picture
@venetianblinds5194
Жыл бұрын
could be gunk on any of the rollers in the fuser, or a grease stain on the belt assembly, or even a leaky toner cartridge causing it. I'd start with the toner cartridge by checking to see if the color of the line matches one of the cartridges and either replace that one or see if there's a line on the imaging drum. If that doesn't work, then see if you can see anything on the fuser or belt around the place where the line keeps showing up (you can line it up with a printout to see where it would be). Because this model's fuser is a challenge to remove but the belt is relatively accessible (just pull the toner tray all the way out and remove the toners) check the belt for a line around the same place in the orientation (do not touch the belt with your fingers within the margins). If you see a greasy spot or anything on the belt then take it out and clean it with a clean soft static-free towel and some isopropyl alcohol. The fuser gunk can be cleaned similarly but use a clean q-tip instead of a rag. Also don't do this while the printer is plugged in unless you like getting electrocuted.
@azidal3755
2 жыл бұрын
The problem I have is how to replace the transfer belt.
Пікірлер: 10