How to remove rear wheel incase of emergency using MotoJack which is possible.
*Loosen all the nuts and bolts *
1. Remove Chain cover
2. Remove Chain Tensioner Bolts
3. Remove only Axle Nut on left side
4. Now lift the Rear Wheel using MotoJack
5. Slide the rear wheel forward after lifting
6. Remove the chain towards leftside
7. Now hold the rear wheel high and remove the Axle bolt
8. Now slowly slide the rear wheel out along with the rear brake caliper
9. Take care of the spacers do the work with rear wheel
Now the assembly very tiring but using right technique it would be easy
IMPORTANT STEP
1.Push the brake pads inside and slide them onto the disc align the Axle hole and brake caliper hole moving forward
2.Now lift the rear wheel align the holes of brake caliper,wheel and swing arm use a temporary bolt/screw driver insert into it.
Take care of the spacer on the chain side so that it can align later.
3. Now insert the Axle bolt through the hole of the swing arm and rear wheel by lifting the rear wheel and with slight angle.
4. Once everything is done before tighten the Axle nut adjust chain tension
5. Tighten all the removed nuts and bolts
There would be pressure on side stand but in case of emergency it is only way to go.
IT REQUIRES SOME PRACTICE AND PATIENCE
SOMETIMES YOU NEED HELP TOO.
NEVER HESITATE TO ASK FOR HELP WHILE DOING ASSEMBLY IT WOULD BE DIFFICULT IF NOT DONE CORRECTLY.
Finally tools are there to help we need to figure out the right method and safe method we can place some bricks to support rear suspension if available.
(Will post the video soon)
Негізгі бет How to Remove rear wheel in Yezdi adventure
Пікірлер: 1