Is this the same location for a 2013 camaro? I bought a 2013 camaro that had been crashed before all airbags were replaced but the air bag light is still on could it be that they dint reset the module?
@MyAirbags
3 жыл бұрын
It might not be exactly the same for the 2013 model but should be pretty similar. If your light is on, the first step is to diagnose the airbag light. Hook up the scan tool / scanner to the car and read the airbag codes. You connect the scan tool right into the OBD port/plug. Its usually located below the steering wheel, on the left. You are welcome to reply to us with the trouble code that it reads. www.myairbags.com
@johnnyaberg9617
4 жыл бұрын
Thank you for a interesting video! I have bought a Camaro 2012 with air bag service light on. As far I know no airbags accidents have been but seems to be common with airbag module problems on these Camaros. I pulled the codes today and got "reset high voltage disable request after crash event detected" and these codes: U00700 Can Bus Communication, B101D00 Electronic Control Unit Hardware, B132503 Control Module Power Circuit Lower voltage, U17000 Lost Communication with passenger presence Module B00210D Passenger seat side airbag deployment loop - high resistance B008100 Passenger presence module Will these problems be solved if you reset the SDM module? And what is the cost if so?
@MyAirbags
4 жыл бұрын
Hi Johnny, Thank you for your question! Our reset service is only beneficial if the car was in an accident.
@johnnyaberg9617
4 жыл бұрын
@@MyAirbags I will send my airbag module to you for my Camaro 2012. Can you please advice where to find it and how to remove it? I guess the module is in the console?
@MyAirbags
4 жыл бұрын
@@johnnyaberg9617 If the car was not in accident, you don't need the reset service.
@racerxxxonlyracingwilldo4919
5 жыл бұрын
Question: my 2017 Camaro will be used track events and hopefully within the next year time attacks, it is not my daily driver only use it for track days I'm thinking about removing the module and disconnecting the units because I will be going with full race seats, will I still get the check engine light on or will I be able to take it off once the modules are completely removed from the car?
@MyAirbags
5 жыл бұрын
RacerXXX, Thats a very solid question! Even though it must be awesome to watch your Camaro fly down the track, I'm sorry, we are not able to advise you on removing safety features from it. We only specialize in restoring the airbag system back to a functioning state. May the Checkered Flags be in your favor :)
@racerxxxonlyracingwilldo4919
5 жыл бұрын
@@MyAirbags Thanks
@jaimeluna9943
5 жыл бұрын
Hi i have the same car && i have a question after an car accident do i have to change the sensor of the air bags ?
@MyAirbags
5 жыл бұрын
If you are referring to the main airbag control module sometimes to referred to as a computer / sensor, We can reset it for you.
@batman607
3 жыл бұрын
@@MyAirbags Jaime is talking about the sensors on the core support and beside seatbelt area on the both sides of rear seat under the side panel trim.
@jonathanvillapudua3995
5 жыл бұрын
I bought a salvage 2017 camaro and the airbags were replaced. The airbag light is still on. How can I take out that light from my dashboard.
@MyAirbags
5 жыл бұрын
Jonathan, Make sure to replace any airbags that deployed. On the Camaro 2017, the seat belt pretensioners deploy as well. You have dual stage seat belts in that car. You can replace those or have them professionally rebuilt here with us. The sdm derm unit / airbag module needs to be replaced or reset. We can reset it for you as well. It only takes 24 hours to turn your order around once we receive it. You can start your order here: www.myairbags.com/product-category/repair-return/airbag-module-reset/?_make=CHEVROLET&_model=CAMARO&_year=2017
@ATROXCUSTOMS
3 жыл бұрын
My car wasn’t in an accident just pop up the code B101D00 and can’t take it off!
@ATROXCUSTOMS
3 жыл бұрын
2018 Camaro ZL1
@MyAirbags
3 жыл бұрын
blogs.myairbags.com/gm-vehicle-airbag-code-b0081/
@danieltorres2965
3 жыл бұрын
My 2017 was not in a wreck my light just randomly came on
@MyAirbags
3 жыл бұрын
Daniel, The first step is to diagnose the airbag light. Hook up the scan tool / scanner to the car and read the airbag codes. You connect the scan tool right into the OBD port/plug. Its usually located below the steering wheel, on the left. You are welcome to reply to us with the trouble code that it reads. We can help with after accident / salvage vehicles where the person is rebuilding the vehicle. We help our customers save hundreds of dollars on the airbag computer/module and the seat belts: www.myairbags.com
@arturonaranjo9206
4 жыл бұрын
Where are u located in California
@MyAirbags
4 жыл бұрын
Arturo, we don't have a Cali location yet. Our customers ship directly to our headquarters. Our site: www.myairbags.com
Пікірлер: 21