Great tips, thanks! You are like a NASCAR pit crew with that impact! 😄
@EricksonMachinePerformance
6 ай бұрын
Thank you! I have removed thousands of studs over the years. It's like second nature at this point
@Drakester55
4 ай бұрын
Any tricks on cleaning the Ada racing head and domes without damaging them? Seems like the guy who installed it put some 1211 in the big o ring.
@dustinwild
6 ай бұрын
Hey Mark, great video! Just ordered myself one of these off the amazon.. $30 up here in Canada.. Not sure how good it will be, but I don't have a lot to do, just an SXR-800 head, and maybe a few others on my 550's.. You wouldn't happen to be planning a little video on porting that 800 head would you? ;) That would be nice! Thanks for the videos, and always great advice!
@EricksonMachinePerformance
6 ай бұрын
I can do that we are getting ready to port 1 tomorrow
@dustinwild
6 ай бұрын
Is it worth doing much on the 800's with stock exhaust? I can't afford 2k for a pipe.. but I would like to open it up a bit. Need to do a top end refresh, figured while I have it apart, I can make it breath a bit more.
@jamesgustin4195
6 ай бұрын
Double nut and heat along with pb blaster
@EricksonMachinePerformance
6 ай бұрын
It's definitely a successful method. But you should try one of the stud removers. They make life way easier
@АлександрПушкарёв
6 ай бұрын
Марк приветствую! Очередное отличное видео ! Подскажи пожалуйста где курить такой инструмент?
Пікірлер: 11