First - disconnect the - battery terminal (someone should put a high-voltage switch in - to make it easy) for the case if Side Airbag is installed inside A-Pillar trim.
You pull back the door trim stuff that runs around the edge of the A plastic. Then you can pull the A out at that spot - you will pull it out and back a bit - about an two inches - the pillar snaps out and back *but* there is this thing holding it. That *thing* has some weird connector - it needs to be twisted 90 degrees then you then you can pull out the trim...... I used a needle nose, twisted 90, pulled, and all was fine.
Reassembly is reverse - you need to twist the thing to get it back (not too hard), and plug and tuck.... Lots of room for wires...
Негізгі бет Тәжірибелік нұсқаулар және стиль How to remove Toyota Prius A-pillar trim cover shell easily
Пікірлер: 1