I just did this yesterday. Hot tip for the front passenger side nut - throw a bit of tape over the ring end of your spanner to hold the nut in place or you'll end up with sore hands like me. Stubby spanners are the go for those front bolts too
@johnhannonHanno
Жыл бұрын
Mate, I would no doubt hit the supports.
@buster_1972
Жыл бұрын
Nice rig.
@mitsalloy
Жыл бұрын
Thanks 👍
@bonnorthcott3557
Жыл бұрын
You know what would good with this is air Suspension so you can just lower the Ute without Cranking the cranks
@Rhysroll
Жыл бұрын
How did you manage to use that spanner on the front bolts without taking off the mud guards ?
@mitsalloy
Жыл бұрын
Most dual cabs are relatively straightforward, depending on wheelbase. Some vehicles may take a while longer, depending on the wheelbase and if they have a front box etc
@Rhysroll
Жыл бұрын
I thought you said you would answer any questions
@mitsalloy
Жыл бұрын
@@Rhysroll Aaron put the spanner in there. Some vehicles may need a smaller spanner, or to take the guard off. Very situationally dependent on the vehicle and tray setup.
@Rhysroll
Жыл бұрын
So do you need to take the guards off the Bt50 ?
@claudyboulaye286
Жыл бұрын
@@Rhysroll something I did with my canopy setup (not MITS though) is holesaw a hole in the mudguard so I can fit a socket with nut and washer in there 👌 then use a rubber plug to plug the hole up
Пікірлер: 12