Replacement toilet button at amzn.to/2CiRs4q
After 50 years of uninterrupted operation, the flush button, Catis type, began to show signs of evident failure: pressed empty, difficulty in operating the flush, button stuck, etc ...
In most cases it is sufficient to unscrew the button plate, extract it and grease the cylinder, the button plunger and all the other mechanical parts involved, even those in the water tank with good grease.
If, as in the case of the video in question, the wear of the cylinder that acts as a plunger is accentuated, the grease may not be enough, therefore to avoid an expensive replacement you can try to restore a few microns in diameter by adding a very thin layer of glue to good quality hot to the cylinder.
Reassembled everything and lubricated equally with the usual grease, the chances that everything will work perfectly again increase considerably, so as to delay replacement as much as possible or even avert it altogether.
I decline any responsibility for any damage to people, animals and things that may occur to anyone wishing to imitate the procedure illustrated in the video which is for entertainment purposes only. I await your comments, likes and subscriptions to the channel. Soon. Thanks for watching. Hello.
#diy #hydraulics
Andrea's Toolbox
Негізгі бет How to repair a Catis-type toilet flush button with a few cents (fix push button toilet)
No video
Пікірлер: 22