Nice job! I love people sharing information on Honda equipment.
@austinado16
8 ай бұрын
Thanks! I'm currently waiting on a fresh set of decals for it, and the upper mount bushing parts, but it runs great, and I actually used it yesterday. It was a fun little score.
@robinlivingston5796
5 ай бұрын
Thank you, Your narration is easy on the ears.
@austinado16
5 ай бұрын
You are welcome! Thanks for watching, and for your kind words!
@ron827
5 ай бұрын
Well done for a tailgate mechanic. BTW, adding oil to the cylinder and compression testing can be done without removing all the shrouding but not rope repalcement.
@austinado16
5 ай бұрын
Correct! No need to remove the generator body just to do a dry, and then a wet, compression test. Thanks for watching!
@leguirerj
8 ай бұрын
Thanks for the video. It is very informative. I have 2 EU2200i's. I think I will know what to do if I have to change the pull rope. Or at least be able to tear it down and put it back together.
@austinado16
8 ай бұрын
You're welcome! It would have been nice to have been able to show how to get the 2 screws loose that are located up in the handle, using an impact driver, and a long phillips head screw driver bit from Snap-On. Rarely do they ever come out with just a screw driver and normal hand pressure.
@mattwaters6987
4 ай бұрын
Nicely done. Thanks for sharing. Did you figure out how many running hrs roughy on it?
@austinado16
4 ай бұрын
No I didn't, and a neighbor has been using it out at their rural property, so it's back in service, and living that Honda life.
@sommaykongmalay8492
Ай бұрын
Hello, I have an EU2200i generator that won't start. It's about 5 years old but has only been used three times, each time for a couple of hours. I removed the carburetor, but it looks brand new but I cleaned it anyway but still won't start. The oil is good and at the right level, and I have fuel in the carburetor bowl. I've also confirmed that there's a spark. I just installed a new OEM carburetor, but it still won't start, and it feels the same as with the original carburetor. I haven't checked the compression yet because the generator is almost brand new. Am I missing something? Thanks in advance.
@austinado16
Ай бұрын
Tough to keyboard diagnose due to it's age, intermittent long term storage, and other factors.
@kacy633
7 ай бұрын
What part of the the US do u reside and do you do repairs on these generators? I need a repairman in sacramento california.
@austinado16
7 ай бұрын
I'm sure there are quite a few power equipment dealers in the Sac area.
@bulkchart3239
8 ай бұрын
why didn't u change the timing belt before it breaks and ruins the engine?
@austinado16
8 ай бұрын
That was day 1 with the machine, and was merely an attempt to take it from it's unknown condition, to running. Parts have been ordered for it, and should be here later this week.
@billcoomber4642
4 ай бұрын
Replacing the timing belt is a major tear down and unless this generator has a ton of hours and the belt is cracked, it will be just fine.
@chrischris1782
5 ай бұрын
how many hours did this have on it? the green power indicator blinks when you first start it. each blink is 100 hours.
@austinado16
5 ай бұрын
I'm aware of the blink indicator. I didn't check.
@doglegjake6788
2 ай бұрын
This cheap American gas carbon's up Those small engines really bad.
@austinado16
2 ай бұрын
It's only an issue on the gensets that sit all day running at idle, especially at "off-grid" home sites. The models that are used normally, don't have an issue.
Пікірлер: 21