Hi everyone.In this video I'm gonna show you how to repair the blinking problem in 50 watts flood light.
It blinks for sometime and then it works normally.so then there is no problem with the LEDs.The problem is with the LED driver.
Remove the back cover and the heat shrink tube.After that discharge the main capacitor using screwdriver as shown in the video.Then visually look for any damages of. the components.If any then change them.
This type of problems are caused because of the weak capacitor.so change the filter capacitor near the output point.
still the same problem continues then change the small capacitor .
This will surely work but be careful while checking and changing the components.
#Tips:
1.)check the polarity of the capitor in board before soldering the component.
2.) use the same micro farad value of the old one and voltage also very important.
watch the video without skipping as it will be usefull and helpfull .
Thank u for watching this video ☺️❤️
pls "subscribe" and support my channel for more videos...
Негізгі бет How to repair blinking "Flood Light" in tamil 💯...
Пікірлер: 2