You should avoid 90 degrees edges on patch... circular patch will perform better over time
@scottharmon709
2 жыл бұрын
Acetone won't melt the material? I would have figured denatured alcohol for cleaning. Of course, I also noted the date this video was posted...
@benskai2475akurfishing
Жыл бұрын
Greetings from Indonesia, senior, please allow me to watch the video
@rickypyun
3 ай бұрын
how long should a repaired leak last?
@FLAdamRX
2 жыл бұрын
I had a small hole on the bottom of a brand new board, but it was located in the sticker that says BOTE. Acetone immediately started removing the black color of the sticker and made a huge mess!
@gerryc1982
6 ай бұрын
What pump is that? Where can I get one?
@jamesdunn9158
Жыл бұрын
Which pump are you using in this video?
@np4057
29 күн бұрын
This is the opposite of anything I’ve learned. I always learned round patches are best, to let the glue dry at least 24 hours, and to use a good amount of glue and to clean the excess up. But I guess you guys probably do this often so what do I know maybe I’m wrong
@sueegg3640
2 жыл бұрын
You said the valve was not part of warranty. So if valve is at fault, how expensive is it to replace or is it replaceable?? These Bote products are Not cheap!!
@bluegreenworld333
Жыл бұрын
I bought a spare valve for my ae1004, it cost £10 and I bought the spanner it didn't need the valve, just tightening. I guess it's not a warranty issue as its a maintenance thing checking valves.
Пікірлер: 10