Absolutely the best, most informative video for this subject on KZitem! Thank you so much
@hanitwfik
Жыл бұрын
thank you so much 🙏
@Emprezita
4 ай бұрын
Thanks for the help
@hanitwfik
4 ай бұрын
my pleasures 🙏
@jjg7696
3 жыл бұрын
Your video was very helpful for helping in replacing the driver side glass on my 2009 F150. The key as you say is to remove both the inner and outer mouldings so that there is clearance to lower the glass to the mounts. Great work, thanks again
@hanitwfik
3 жыл бұрын
I really really appreciate your kindness words
@joeboe4794
2 ай бұрын
I have this same truck but need to do the back door window. There is not a single video on the internet for a 2006 f150 extended cab rear door glass replacement. Can anyone help me
@hanitwfik
2 ай бұрын
FOR SUPERCAB, WINDOW GLASS - REAR DOOR Removal and Installation 1. Remove the rear door trim panel. 2. Remove the rear door mounted speaker. 3. Remove the rear door interior moulding. 4. Remove the rear door watershield. 5. Remove the C-pillar below belt bracket bolt and bracket. - Slide bracket down to disengage from U-channel in door. - To install, tighten to 10 Nm (89 lb-in). 6. Remove the B-pillar below belt bracket bolt and bracket. - To install, tighten to 10 Nm (89 lb-in). 7. NOTE: Some vehicles may use rivets instead of rear door window glass-to-regulator assembly bolts. Remove the rear door window glass-to-regulator assembly bolts. - To install, tighten to 11 Nm (8 lb-ft). 8. Remove the rear door window glass. - Pull the rear door window glass out through the top inboard side of the door. 9. To install, reverse the removal procedure.
@hanitwfik
2 ай бұрын
FOR SUPERCREW, WINDOW GLASS - REAR DOOR, Removal and Installation 1. Remove the rear door trim panel. 2. Remove the rear door mounted speaker 3. Remove the rear door interior moulding. 4. Remove the rear door watershield. 5. Remove the C-pillar below belt bracket bolt and bracket. - To install, tighten to 10 Nm (89 lb-in). 6. NOTE: Some vehicles may use rivets instead of rear door window glass-to-regulator assembly bolts. Remove the rear door window glass-to-regulator assembly bolts. - To install, tighten to 11 Nm (8 lb-ft). 7. Remove the rear door window glass. - Pull the rear door window glass out through the top inboard side of the door. 8. To install, reverse the removal procedure.
@adkison361
Жыл бұрын
im about to replace my back seat passenger side window any tips on that or is it same process as front
@joeboe4794
2 ай бұрын
I need to do this, can you tell me how it went?
@adkison361
Ай бұрын
@@joeboe4794 do you need help still I just pulled panels and the window trim inside and out then I went and loosen the window bolts that are holding the window to the motor arm and I loosend the arm assembly so I could adjust window height to the right area where all bolts were accessible then I pulled window up and out twords the outside of truck make sure you pull all the weather strips it makes it so much easier to put in and out of truck door
Пікірлер: 12