Great video.. 1999 chevy tahoe turns but no start. New battery, starter. Fuel pump test turn key @58psi.
@sonnybugarin5049
4 ай бұрын
Just saw your video. Doing the same thing. My OEM fuel pump had the foam black sleeve around the pump. Notice new pump didn’t have black foam sleeve. I ordered the OEM pump Module and it had the black sleeve on the pump. The black Steve deteriorated causing to block the filter. Should I remove the black sleeve and leave it off? What would be the advantage and disadvantage.
@KNKRNR
4 ай бұрын
The black sleeve is a noise insulator. The pump is cooled internally so keeping at least 1/4 or more of fuel at all times in the tank would be better then removing the noise insulator. /K&K
@demonmotorsports99
4 күн бұрын
Great vid.. i think im gonna have to do this for n my bucket truck.. but i have to say using that vac was a bad idea. You definitely sucked in gas fumes and those motors throw sparks inside. I seen a guy burn half an industrial complex down sucking fuel in a vacuum
@KNKRNR
4 күн бұрын
Thank you for the comment. It does make me nervous using a shop vac as well. We always blow the sending unit with compressed air but it doesn't get all the trapped dirt out. I should get a vacuum that uses compressed instead to be safer that's for sure. I'm not trying to blow my shop up. :) /K&K
@ironlionzion2265
2 жыл бұрын
I rather use Delphi or Ac Delco. I heard Precision is cheap
@KNKRNR
2 жыл бұрын
Agreed, customer supplied his own parts on this one. /K&K
@dougr.6734
3 ай бұрын
Precision pumps are junk.
@tonyedward6909
Жыл бұрын
Best video on YT ! Thanks
@Rider-nb5ts
Жыл бұрын
If this is vortec where is the canister around the pump?
@KNKRNR
Жыл бұрын
Yes the Vortec uses this Fuel Pump Module (FPM) and Fuel Tank size as shown in this video (1996-1999). /K&K
@clos9902
2 жыл бұрын
Im going to do this job on my own any tips?
@KNKRNR
2 жыл бұрын
Make sure you have the tools on hand to do this job. Tools make all the difference with this repair. /K&K
Пікірлер: 13