Replacing an igniter in a Pit Boss is so easy you can do it at home with just a Phillips Head screw driver, as daunting and scary as it sounds.
Andrew walks us through the steps.
You'll need to take out the grates and flame broiler (big piece of metal) over the fire pot to do this.
Step 1: Remove the 4 phillips screw holding the fire pot in place
Step 2: Turn the fire pot a little and pull it out.
Step 3: Tilt it so you can see the phillips screw holding it in place. Loosen it and slide the Igniter out.
Step 4: Slide the igniter back through the tube it lives in
Step 5: Remove the 8 phillips head screws on the bottom of the hopper that hold the plate in place.
Step 6: Clip the zip-ties holding the wires.
Step 7: Fish the igniter back through the hole and out from the hopper. You can use its tough coarse wires to guide it.
Step 8: The igniter is connected with the White and Purple cable to the grill's board. Just unplug this, its a bit tough so pull hard.
THAT'S BASICALLY IT. After you swap the igniter for a new one, do all the steps in reverse. So:
Step 9: Feed the igniter back through its hole into the tube it was removed from.
Step 10: Reconnect purple and white wires to the igniter.
Step 11: Tuck wires into the carriage and replace the grate.
Step 12: Feed the igniter up towards the fire pot and you can stick it into the opening for it.
EXPOSE 1/4 to 1/2 INCH FOR THE IGNITER
Step 13: Tighten the set screw to keep the igniter in that position.
Step 14: Place the fire pot back into its housing, turn to tighten, and replace the screws.
Негізгі бет How to Replace an Igniter on any Pit Boss Wood Pellet Grill | Pit Boss Pit Stops
Пікірлер: 179