Buy Now!
New Crankshaft Position Sensor from 1AAuto.com 1aau.to/ia/1AEC...
This video shows you how to install a new crankshaft position sensor on your 2007-2010 Chrysler Sebring. The crankshaft position sensor is an important component of any electronically controlled ignition system. The sensor provides the computer with data about the position of the crank shaft to properly adjust ignition timing. If the sensor in your vehicle is broken or malfunctioning, you may suffer poor performance, or get a check engine light.
This process should be similar on the following vehicles:
2007 Chrysler Sebring
2008 Chrysler Sebring
2009 Chrysler Sebring
2010 Chrysler Sebring
Tools you will need:
• Phillips Bit in a Ratchet 1aau.to/oa/1AXA...
• Pry Bar 1aau.to/oa/1AXA...
• 10mm Socket 1aau.to/oa/1AXA...
• 13mm Socket 1aau.to/oa/1AXA...
• 7mm Socket 1aau.to/oa/1AXA...
• Trim Tool Set 1aau.to/oa/1AXX...
• Pliers
• Ratchet 1aau.to/oa/1AXA...
• Socket Extensions 1aau.to/oa/1AXA...
• Swivel
• Torque Wrench 1aau.to/oa/1AXA...
• Drill
• Engine Oil
• Gloves 1aau.to/oa/1AXS...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Негізгі бет How to Replace Crankshaft Position Sensor 2007-2010 Chrysler Sebring
Пікірлер: 5