√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
@Levitabis
Жыл бұрын
This is a savior I was doing a 2011 tsx with the same handle and was losing my mind until I found this 👍🏾
@IrisLeary-j8h
3 ай бұрын
Addendum! Great teaching voice. Easy to listen to.
@tzonkel
9 ай бұрын
Great video. Replaced my door handle today with no issues. Thanks!
@TRQ
9 ай бұрын
+@tzonkel Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-TRQ
@herbrawling2955
Ай бұрын
Great, informative video! One question: I just had the rear piece of the door handle fall off, the one with the keyhole (on the driver's side). The lock itself is now loose. Is there any way to get the door handle cover back on and secured without taking the door completely apart (as you show in the video)? Also, best guess: is it the nut holding the lock in place that broke or fell out that enabled the rear piece of the door handle cover to fall off? Thank you!
@LUk3.M.
4 ай бұрын
Thanks for the video. Pretty helpful. But still not an “easy” job. I definitely let out a few bad words during the install. And after I had the handle already off I had a few minutes where I thought I wasn’t gonna be able to get it back together and I’d have to take it to the shop, but I didn’t give up and finally somehow I got it to go back together successfully. It’s not HARD but it took me about 90 minutes and all my effort. So it wasn’t easy. Hardest part was getting the handle and the other outside piece back on. Hard to keep the lock cylinder in place while keeping the window guide out of the way and pushing/holding the triangle piece on the outside and then trying to tighten the bolt all at the same time. I’m not trying to scare people away from it but I’ve done some other mechanical maintenance and brake jobs and such and this does take some patience. You can do it, but you gotta get your arm into tight spots and have at least a little tool & auto experience.
@williamking9200
Жыл бұрын
I own a 08 Accord Coupe and removed my door panel more times than I care to admit. The best and easiest method is to actually start from the bottom in the center, there's a little hump you can fit your fingers in to pull the panel out twords you to pop it off...
@sherronthejedi
Жыл бұрын
Not all heros wear capes.... thank you
@af2033
Жыл бұрын
How about replacing the master power buttons for the windows ? Would I need to take off the door panel?
@Jmayer1911
6 ай бұрын
Thank you
@adrianoluiz6023
11 ай бұрын
Preciso desmontar o do Honda Accord 2006, é esse mesmo procedimento?
@josesoto7480
Жыл бұрын
Thanks
@il_d8634
Жыл бұрын
Well presented both ways in disassembling and reassembling. This is how Videos should be presented shown fully and properly. Many thanks bud!
@LUk3.M.
11 ай бұрын
How about passenger side? (I need to do both sides)...I believe its slightly different for the passenger handle. Obviously the passenger handle doesnt have the key hole/key mechanism but is there anything else I need to know? Is it pretty straightforward? Is there anything that would make it more difficult?
@surgingcircuits6955
Ай бұрын
Excelent video. Will Done. Thx!
@8755kgftu
Жыл бұрын
Your video was very helpful the only problem I have with my doorhandle is that it was broken . And it took me a minute to remove the piece that was attached to it. Thanks for your video
@TRQ
Жыл бұрын
+Shellette Colline Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-TRQ
@IrisLeary-j8h
3 ай бұрын
Great great thorough. What held me up?I was removing things I didn’t need to. When I removed the plastic I saw 2 bolts connected to the handle. I could reach them with my hand . I wasn’t paying attention. I leave in Shreveport and it was hot hot. I have a 2008 Honda Accord v6 ex-l 4-door. Pristine condition. Just hit 100k. Her name is Ms Genesis. So on behalf of her and myself thanks. May Bless and reward for your time and unselfishness.
@TRQ
3 ай бұрын
+@IrisLeary-j8h Thanks for watching our video! 1aau.to/m/Shop-TRQ
@biggdogg7840
7 ай бұрын
Don't be like me. You Have to take the 10mm bolt out BEFORE you slide the lock cover. I needed this because I had to replace my door with a junkyard door and I needed the old lock
Пікірлер: 22