Buy Now!
New Tie Rod from 1AAuto.com 1aau.to/ia/1AST...
This video shows you how to install a driver's side outer tie rod on your 2008-2010 Ford F-250. Outer tie rods, sometimes referred to as “tie rod ends,” connect the steering rack to the steering knuckle. Their joints can wear out over time, causing loose steering, vibrations, and uneven tire wear. They are also a common failure point in localities with safety inspections.
This process should be similar on the following vehicles:
2008 Ford F-250 Super Duty
2009 Ford F-250 Super Duty
2010 Ford F-250 Super Duty
Tools you will need:
• 13mm Socket 1aau.to/oa7x/1A...
• 15mm Socket 1aau.to/oa7x/1A...
• 21mm Socket 1aau.to/o4E/1AX...
• 22mm Socket 1aau.to/omz/1AX...
• Pliers
• Side Cutters
• 1/2 Inch Impact Gun 1aau.to/oou/1AX...
• 3/8 Inch Impact Gun
• Torque Wrench 1aau.to/oaoQ/1A...
• Anti-Seize Grease
• Gloves 1aau.to/oCZ/1AX...
• Rust Penetrant
• Safety Glasses 1aau.to/owI/1AX...
• Chisel 1aau.to/ojR/1AX...
• Floor Jack 1aau.to/oR5/1AX...
• Hammer 1aau.to/oMD/1AX...
• Wheel Chocks
• Wire Brush 1aau.to/oqr/1AX...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Негізгі бет How to Replace Driver's Side Outer Tie Rod 2008-2010 Ford F-250
Пікірлер: 2