Fine video, gave me great ideas. What worked best for me was to remove the front wheel bearing hub, then upper ball joint. Super easy to get at CV axle, just a bit challenging to remove. Don't compromise on safety.
@3rdzodiac
4 жыл бұрын
Good job but you didn't have to do all that you did. Just remove the 3 nuts from the LBJ, and lift the spindle up and out of the LCA. Now you can remove the axle. Also that "bar" is called an outer tie rod.
@sixcentsmedia
4 жыл бұрын
Just about to replace mine, I appreciate the comment.
@touaregbebe
3 жыл бұрын
I don't know how you removed that drive shaft nut using a 32 millimeter socket , you are supposed to use a 12 point 30 millimeter socket,
@jordanmendoza8726
Жыл бұрын
30 didn’t fit for me, had to hammer in 32 socket
@lobssangmarrero4781
2 жыл бұрын
This guy loves some thread lock! Thread lock everything!! Lol
@bobcurt2207
4 жыл бұрын
Better to remove the CV axle from the bottom...does not affect alignment that way, but tough to do in your driveway
@jacobbuckey3511
3 жыл бұрын
Where ya live? I'm coming over to do mine next. Exact car haha
@christiancalderon3821
4 жыл бұрын
Where did you purchased the axle my friend?
@kavinroberts422
3 ай бұрын
Would this process be the same on my 2008 es350?
@Halfpsychopath
Жыл бұрын
Did any transmission fluid come out when you pulled your cv axle out? I had about a quart and half come out. I'm kinda scared to drive it now
@marklance033
Жыл бұрын
Do you have any more videos on this car?
@kellygriffith5866
4 жыл бұрын
Please chalk the tires from now on and for every job lifting the car. The car can still roll and smash things. Like you
@norakat
Жыл бұрын
yeah.. he meant 'chock'
@jeffnpatricia
2 жыл бұрын
Why did you take all that off ?
@jessieellison2511
3 ай бұрын
Cv Alex size is 30 mm 12 point star not a 32
@erickonassis6310
Жыл бұрын
How did you know it was bad
@babatoraa9777
Жыл бұрын
I HAVE SEEN IN USA ALMOST MAX PEOPLES DOING REPAIR VEHICLE HIMSELF! WHY WORKSHOP EXPENSIVE OR WHAT?
@trevorj203
Жыл бұрын
You do not need to remove the tie rod
@thanavitz7548
3 жыл бұрын
lamo.... this is definitely not a how to
@BackonthefarmLance
4 жыл бұрын
Good video, but too much talking.
@biggestc9850
2 жыл бұрын
Wrong socket sizes bro,many unnecessary steps. Delete vid please
Пікірлер: 23