√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
@capju854
2 жыл бұрын
good video, great, will remember TRQ
@michaelhiscox156
11 ай бұрын
High praise to everyone involved in this production. I used to make instructional videos for a living and can attest that this is excellent in every way.
@almostwhite27
Жыл бұрын
Wow, this is well explained-- I don't even have a xB, but this is filmed nicely!
@HenryPorter332
2 ай бұрын
This is a great video. While not exactly the same, it was a close enough process to help me through replacing my Scion XD's struts.
@typhoon320i
2 жыл бұрын
I wouldn't think you need to remove the axle nut. Is there not enough flexibility to separate the strut, and the knuckle otherwise?
@seantherien1916
8 ай бұрын
So I didn't take anything off that wasn't directly bolted to strut lol. So much extra work for no reason. No need to loosen the axle nut. No need to touch a windshield wiper/motor.
@jefforris8119
10 ай бұрын
Great video. Thanks for pointing out the valve stem
@kb7uxe
Жыл бұрын
thank you for a very complete video. Showing how to remove wiper tray etc.. great dialog. Thank you . kb7uxe
@AVPcreationsavp
3 күн бұрын
Amazing video
@eazye1498
2 жыл бұрын
Len pretending to bottom out that broken bolt on the cowl bracket 😂😂😂
@capju854
2 жыл бұрын
GOOD video. great, will remember TRQ,
@anunpopularstance
6 ай бұрын
Why did you remove the axle nut? It was not required to remove the struts.
@capju854
2 жыл бұрын
good video, great, will remember TRQ
@capju854
2 жыл бұрын
good video, thanks, great, will remember, TRQ
@jeremiahdelossantos3035
5 ай бұрын
My alignment shop said that I need camber bolts. Replaced with factory springs that bought from you. It's stock, why do I need camber bolts?
@jllanesphoto
Жыл бұрын
Excellent video , Thank you Sir.
@eddieyan5529
3 ай бұрын
MUST HAVE THE WHOLE FRONT IN LIFTED BEFORE YOU BEGIN!!!! Having one side lifted will not work because sway bar will not allow the knuckle to fully drop
@mohabens5469
9 ай бұрын
Great video. What size socket did you use for the axle nut?
@paulrevere9071
Жыл бұрын
you don't need to do all of the gyrations with the cowl and the wiper assemblies. 12mm is all you need. I did it. And, what about the way the 30mm nut is "staked" on. you'll destroy the threads on the drive shaft and the nut. I know, because I did it.
@Alex-ti3uf
11 ай бұрын
You can cheat not removing the cover.
@typhoon320i
2 жыл бұрын
Drilled and slotted rotors with, Rusty ass steelies, and calipers? LOL!
@KickingtheDonksNuts
Жыл бұрын
that's not the point of this video. It is covered in another video
Пікірлер: 23