I used a pipe wrench to hold the hex plate while taking the top nut off. It worked great. Also that top nut can be over tightened, I think it’s supposed to be just snug once the car is on the ground, but I could be wrong. Thanks for the video! Made the process much smoother
@VictorRodriguez-ty9uj
2 жыл бұрын
Thank you so much. I changed rear shocks. I ordered front struts and doing those next so this was a nice video for me.
@AnthonyMejia-t6k
4 ай бұрын
Thanks....i have a tracker...i needed.to know how to Thanks for the lesson.very helpfull
@audiophilesound8783
2 жыл бұрын
Good Work Man, very instructive
@trackerbro2472
2 жыл бұрын
Thanks for watching!
@scotfield3950
Жыл бұрын
Well done and thank you!
@daleg9141
3 жыл бұрын
Good instructions, I would have washed the rubber covers and used all new stuff that came with the struts. Only other step is putting the engine compartment on first because it is easier do the bottom struts bolts...
@trackerbro2472
3 жыл бұрын
Thanks for the tips
@JuanRodriguez-kf5rf
3 жыл бұрын
Good job hombre excelent tips👌
@rodolfoalfaro4982
3 жыл бұрын
Awesome, thank you for the video
@joesroque
3 жыл бұрын
Hey does really make big difference on this car to change these and the back ones ? I want to change these on my tracker they are not bad yet but I feel that is not going to feel comfortable and tight even after changing these
@trackerbro2472
3 жыл бұрын
Yeah, it doesnt make a really big difference especially using cheap ebay shocks but I did notice a very small improvement in ride quality and handling. The shocks I replaced had 240,00 miles on them but they still worked well.
@rogerbranch8837
3 жыл бұрын
Thank you looks simple
@GM-qw7ll
3 жыл бұрын
Very helpful, thanks
@trackerbro2472
3 жыл бұрын
No problem
@VictorRodriguez-ty9uj
2 жыл бұрын
Got a question. Anybody know where I can find a fuel sending unit for 1994 Geo Tracker?
@khalidqasimbungash7258
Жыл бұрын
Do need wheel alignment after replacement front shocks
@trackerbro2472
Жыл бұрын
I'm sure an alignment would be good for the car, however I didn't get one and the car runs and drives just fine.
@khalidqasimbungash7258
Жыл бұрын
@@trackerbro2472 Thanks ..I will try without doing wheel alignment
@plantbasedprepper
Жыл бұрын
All you had to do is remove that one middle bolt on top. You did extra work. I just did mine. It was easy peasy. kzitem.info/news/bejne/0Xdnx42Qa3eEdKQ
@kevinmckay810
Жыл бұрын
This gripper thingy
@pauleyestone7739
2 жыл бұрын
Balts
@FatKidatSpeed
9 ай бұрын
Please go buy a proper jack and safety stands. Those scissor jacks are dangerous...
Пікірлер: 25