you should disconnect wire ( to prevent twisting)and then drain out old fuel fuel. Also, you should take out the O ring that is stuck on mount, inspect it, lube it and reinstall it in groove located on filter housing. Just my suggestion for anyone watching this video. Otherwise...nice job.
@Whitie7Original
2 жыл бұрын
There is a special wrench for that filter. It’s never that easy to remove. If you use channel locks to remove be prepared to replace the housing because there’s a good chance it will crack at a cost close to $200. Canadian
@kingdavid2684
Жыл бұрын
You will crack it with channel locks if you dont know what you are doing...trust me.
@reelnative01
7 ай бұрын
I hope people read my post first you disconnect the wires come from the bottom of the filter housing Iys a blue clip and easy to disconnect and this is on all newer 150 and up then u screw and if the fikter comes out like in this vid you have an issue you need to push that filter up into the neck of the top of the filter housing if you do like this guy did you are not getting any filtration the filter has to be pushed up onto the neck the filter will be suspended by itself then screw the filter cup into position and then connect the blue connector again also there is another small inline filter that can be changed also in the fuel line after this filter and before the vst tank, man I hate that fools post vids like this and people see them and run the risk of damaging there 20k plus motors this vid should be taken down
@butchg3990
2 жыл бұрын
Fuel contamination. #1 cause of breakdown on the water. Thx for showing how easy it is.
@timothyledet6273
2 жыл бұрын
Start the bolts by hand then use the driver. Cross threaded bolts are problems.
@Eric-zs6rd
Жыл бұрын
That's no driver, its a full on impact wrench. The m12 right angle impact. Puts out 220 ft lbs of torque. It's a nice tool but hold that trigger down too long and it'll destroy that cover
@Trenchant463
3 жыл бұрын
Thanks!
@jimerscree3802
2 жыл бұрын
easy but i remove blue clip so wires dont twist figure it cant hurt thanks for video
@PetClipdog
3 жыл бұрын
I don't see you disconnected the Blue Connector? Why?
@kingdavid2684
Жыл бұрын
I didnt see a O-ring !
@timsmalley7660
3 жыл бұрын
Needs more volume. Hard to hear.
@성이름-w9q1q
3 жыл бұрын
개중아 멋져버리고만
@rob2388
3 жыл бұрын
Can you dump the old fuel on the filter? Or you have to leave fuel in there? Thank you!
@captainsalty7777
3 жыл бұрын
No need dump the old fuel. Thanks
@jsmith6259
3 жыл бұрын
Why do think Japan makes the best marine engines? Does Korea make marine engines?
@captainsalty7777
3 жыл бұрын
I reckon korea makes inboard engine only not sure why.
Пікірлер: 18