√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*
@moonlightaurora2943
3 жыл бұрын
Been doing this for years was just trying to see exactly where the fuel pump sat. Very great video, appreciate you.
@lancesettler9701
Жыл бұрын
This video was very helpful, also I like the safety tip about fuel that may be still in the line . Just what I wanted. Thank you
@longdong3889
2 жыл бұрын
I just cut a square out of the bed and changed the pump in 20 minutes
@brad2548
Ай бұрын
What was the purpose in removing the tank ? Did the sending unit/pump assembly get replaced ? Was the tank dirty ? Was this for demonstration purposes only ?
@GodWasAnAlien
4 жыл бұрын
Did you happen to notice (or would you happen to know) if there's a check ball in the filler neck for those trucks? Trying to get the fuel out of the tank of a 98 Ranger that's been sitting around for a couple years to replace it with some known good fuel, trying to figure out the easiest way to do it... if there is a check ball valve, think I could probably just drop the tank enough to remove the filler neck and siphon from there?
@johnjude2685
4 жыл бұрын
Thumbs up before I saw this, You always that good thanks
@1AAuto
4 жыл бұрын
+John Jude Thanks for checking us out! 1AAuto.com
@onemanwreckincrew
4 жыл бұрын
On the 1993 Ford Ranger PU (125" wheelbase), the fuel tank would not simply 'drop straight down'. It would not go back far enough until we removed the bolt out of the rear shackle for the leaf springs, removed the driver side shock at the top mount and unbolted stuff on top of the rear axle. What a crappy design... way to go Ford. Can't even buy a fuel tank for a Ranger. What a world.
@trevorsteele341
2 жыл бұрын
I have a 2003 2WD 4.0 and bought a gas tank from a same year 4WD 4.0. The 4X4 has a skid plate and it seems to me that Ford designed this one 1/2 inch shorter in height, therefore my fuel pump does not transfer over. The gasket is also slightly larger. I didn’t want to replace the pump but the gas tank came from 2 states away. What pump do I need?
@dwarftoad
6 жыл бұрын
You should be able to unscrew the filler from the outside rather than taking the hose off, I think?
@Milosz_Ostrow
Жыл бұрын
The filler is secured to the body with three hex-head screws on my 1997 Ranger. It would be very easy to remove, but could be very difficult to reattach unless one has an assistant.
@latination2013
6 жыл бұрын
is this the best way to replace the fuel pump? or bed removal is easier?
@1AAuto
6 жыл бұрын
+Jay Geo This method isn't too bad. Hope this helps you out. 1aauto.com
@morganstanley3777
Жыл бұрын
Bed removal is a Lot better
@ForbiddenPhysics
3 жыл бұрын
My 2011 ranger doesn't have a 50b fuse. Which would it be in my case?
@jacobbundy663
7 ай бұрын
Where does the hose go to that is on the back side of the fuel tank
@onokaya
4 жыл бұрын
Helpful video but it might pay to state the obvious. Get most of the gas out before you start so the full tank of gas doesn't fall on you!
@harry554
Жыл бұрын
Heard of pb-blaster?
@bluetrainer3549
2 жыл бұрын
Hello there, so I have the issue that when I go to fill up for gas the gas tank spits it back out, any ideas on what could be causing this issue?
@drovarela2140
2 жыл бұрын
Fuel vent is not properly ventilated
@mikevonn3420
5 жыл бұрын
If you are trying to do this with just a jack, you really need to jack it up by the frame to get the driveshaft down far enough to be able to get the tank straps off, as seen in kzitem.info/news/bejne/sIGY1Wqtq310nmk
@justforfunvideohobby
Жыл бұрын
thanks for the heads up
@josesalazar7436
5 жыл бұрын
1992 ranger is little different but i want i trying tank you tank you have I god day
@1AAuto
5 жыл бұрын
+Jose Salazar Thank you!
@onemanwreckincrew
4 жыл бұрын
I'm doing a 93 today and the front extended area of the tank does not let one drop the other end of the tank down to go beneath the rear axle. We are stuck.
@joeljohnson79
5 жыл бұрын
What's the connector on the back of the tank ? And what's its purpose
@mh4airsoft
Жыл бұрын
Connector on the back is for the gas fumes canister
@cheech1765
3 жыл бұрын
What does a job like this cost?
@jillbrown9645
3 жыл бұрын
Need a gas tank for a 1997 Ford ranger
@heidimansdoerfer1976
3 жыл бұрын
I do also and can not find one they are discontinued accourding to everyone I have checked with so far.
@pandaman4647
Ай бұрын
it’s a ford ranger remove 6 bolts and remove the 50 pound bed
@TvValenti
4 жыл бұрын
Why can’t there be a video with a 2000 model
@1AAuto
4 жыл бұрын
+Tv2079 Valenti We don't have a how-to video for your vehicle right now, but the basic steps in this video should be enough to do this task. Buy this part for your vehicle on 1AAuto.com: 1aau.to/m/Shop-1AAuto-c
Пікірлер: 36