Buy Now!
New Tie Rod from 1AAuto.com 1aau.to/ic/1AST...
This video shows you how to install an inner tie rod on your 2007-2013 Acura MDX. The inner tie rod has a ball joint that can wear over time, causing a clunking noise, loose steering, and eventually, other problems with the wheel and suspension components. It’s a good idea to replace your inner tie rods as soon as you notice any of these symptoms.
This process should be similar on the following vehicles:
2007 Acura MDX
2008 Acura MDX
2009 Acura MDX
2010 Acura MDX
2011 Acura MDX
2012 Acura MDX
2013 Acura MDX
Tools you will need:
• Flat Blade Screwdriver 1aau.to/oa2t/1A...
• 14mm Wrench 1aau.to/oLg/1AX...
• 24mm Wrench
• 22mm Socket 1aau.to/ok9/1AX...
• Inner Tie Rod Removal Tool 1aau.to/oax/1AX...
• Locking Pliers 1aau.to/oiw/1AX...
• Pliers
• Ratchet 1aau.to/obeU/1A...
• Torque Wrench 1aau.to/oakW/1A...
• Gloves 1aau.to/oyB/1AX...
• Safety Glasses 1aau.to/osR/1AX...
• Wire Ties
• Floor Jack 1aau.to/oPT/1AX...
• Hammer 1aau.to/oK5/1AX...
• Pick 1aau.to/oD2/1AX...
• Rubber Mallet 1aau.to/ofa/1AX...
• Wheel Chocks
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Негізгі бет How to Replace Inner Tie Rod 2007-2013 Acura MDX
No video
Пікірлер: 7