We are going over the steps to replace the outer tie rods for a 2015 Nissan Altima. This is an OEM replacement which is very easy and quick to install.
Note: A Wheel Alignment is required after replacing the Tie Rods, otherwise your vehicle will not track correctly and cause tire wear.
1. Intro - 0:01
2. Step 1 (Loosen Lug Nuts) - 0:16
3. Step 2 (Lift Vehicle) - 0:35
4. Step 3 (Remove Wheel & Lug Nuts) - 0:53
5. Step 4 (Mark Tie Rod/Jam Nut Orientation) - 1:09
6. Step 5 (Loosen Jam Nut) - 1:41
7. Step 6 (Remove Cotter Pin) - 2:36
8. Step 7 (Loosen Ball Joint Nut) - 2:55
9. Step 8 (Remove Tie Rod from Steering Knuckle) - 3:16
10. Step 9 (Remove Tie Rod) - 3:57
11. Step 10 (Install New Tie Rod) - 4:48
12. Step 11 (Install Ball Joint Nut/Washer) - 5:16
13. Step 12 (Torque Ball Joint Nut) - 5:39
14. Step 13 (Install Cotter Pin) - 6:16
15. Step 14 (Tighten Jam Nut) - 6:50
16. Step 15 (Install Wheel & Lug Nuts) - 7:13
17. Step 16 (Lower Vehicle) - 7:28
18. Step 17 (Torque Lug Nuts) - 7:45
19. Step 18 (Repeat for Passenger Side) - 7:57
20. Cost Savings - 9:18
Products Used:
This video contains affiliate links for which I may receive compensation.
Outer Tie Rod (Passenger Side) - www.oreillyaut...
Outer Tie Rod (Driver Side) - www.oreillyaut...
Ball Joint Separator - amzn.to/3GSgB3Q
Paint Marker Pens - amzn.to/3GVuOg4
1/2 in. Digital Torque Wrench - www.harborfrei...
3/8 in. Digital Torque Wrench - www.harborfrei...
Tools:
1/2" Socket Wrench
3/8" Socket Wrench
1/2" Breaker Bar
19mm Socket
21mm Socket
22mm Socket
24mm Socket
19mm Wrench
22mm Wrench
Ball Joint Separator
Heat Gun
Jack Stands
Jack
Needle Nose Pliers
Paint Marker Pens
Torque Wrenches (Req: 25-83 ft-lb)
#TieRod #Altima
Disclaimer: Content produced from Mcgurr Entertainment is for entertainment purposes only. This information is not endorsed by any agency/company (such as Ford) and is intended as an entertainment. Mcgurr Entertainment assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. All content on KZitem is provided in good faith, however we make no representation or warranty of any kind, express or implied, regarding the accuracy, adequacy, validity, reliability, availability or completeness of any information on KZitem. Use this information at your own risk.
Негізгі бет How to Replace Outer Tie Rods for Nissan Altimas (2013-2018)
Пікірлер: 23