√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
@andrewfulton4129
3 ай бұрын
Exactly what was the point in removing the inside door panel? All the work was done from the handle .
@ronhat-nx6yq
4 ай бұрын
Use a pair of long nose pliers to grasp the cable, pull it forward and out of the recess.
@danielcotter9202
5 ай бұрын
What size is the appropriate rivet to use to install these back on? I have a 1998 ranger and can’t find which size rivet to use? What size did you use for this? Thanks
@anthonydilligaf823
7 ай бұрын
..I used 6mm stainless pan head screws to do my front door handles. Seems more than sturdy enough, looks fine and since Tesla wasn't involved they shouldn't rust. I did double nut them with lock washers on the back. They're not hard to reach. It looks like i can get by with the rear doors. I'll post again if I'm wrong. 😂
@ronhat-nx6yq
4 ай бұрын
NO! Do not continue drilling that rivet with that huge drill bit or you will enlarge the rivet hole. Get the right size bit.
@ronhat-nx6yq
4 ай бұрын
The center pin is steel. The rivet is aluminum. The center pin throws your drill off center and is very hard to drill out. It is a mistake to rivet these handles back in. Just use a couple right sized sheet metal screws in case you must again remove the handles.
@ronhat-nx6yq
4 ай бұрын
To slide the plastic sliders just press the ends together a bit and push the sliders up. Do not remove the sliders completely.
@ronhat-nx6yq
4 ай бұрын
On most of these door handles, the plastic sleeve on the cable ends has crumbled. They can be replaced with metal sleeves.
@ronhat-nx6yq
4 ай бұрын
If you do the sliders as he does them here, you will damage the sliders.
Пікірлер: 11