Difficult to get the information we need with that camera going all over the place LOL
@KingMechanics
Жыл бұрын
Difficult to please everybody. It’s always in complaining
@sergioca1208
Жыл бұрын
Thank your for the video. Every tip helps out. Would you happen to the best way to replace the rear axle seals? The Autozone Seal Puller doesn't work. I asked the local Dodge repair shop but they were not helpful...unless I give them some business. It's all good lol For 2010 Challenger V6 3.5l Thank you.
@KingMechanics
Жыл бұрын
Try picks, flathead screwdrivers. Remember you can damage the old seal because you’re replacing it. Just don’t chip any metal surfaces
@wills4187
Жыл бұрын
How did you get the knuckle back on the lower control arm? Mine doesn’t seem to want to cooperate lol
@KingMechanics
Жыл бұрын
If you have to open up that “clamp” on the lower side of the knuckle. Use a wedge or pry bar to gain necessary leverage
@Motowntransportmovingco
2 жыл бұрын
What size is the bolt in the middle of the wheel the one you was banging with the hammer
@KingMechanics
2 жыл бұрын
32 mm axle nut
@kirkkoblect5915
9 ай бұрын
How the hell u get those lug nuts off with a drill
@KingMechanics
9 ай бұрын
Big boy impact
@jayphd395
Жыл бұрын
Did you have your tires wearing down from the inter side
@KingMechanics
Жыл бұрын
My client’s vehicle was wrecked, but a inner tire wear is a sign of suspension issue
@jayphd395
Жыл бұрын
@@KingMechanics I want to put it in the shop, but at the same time i want to do it myself, what do you recommend
@KingMechanics
Жыл бұрын
Do it yourself. Just make sure you can get the axle off
Пікірлер: 16