Making such videos is invaluable work. My utmost gratitude.
@arthurmajor952
Ай бұрын
Nice job done!, have a qestion , I notice after you lower the vehicle , you drove the car on a ramp, and torque down lower control arm, my question is can I do that on the rear strut, drive rear end on ramps and torque down lower control arms? Or will it throw off my rear end camber alignment? And thank you for show us the great job in how to install struts on these BMW, also can you give me the torque spec for the rear lower control, great job again,
@katkiller50
2 жыл бұрын
This is a good video, but the Sachs original strut is the way to go..unless the Bilsteins were under $100 each... Ive seen their priced about the same, so the Sachs would save a few steps....
@christophelabourier2852
Жыл бұрын
Hi, very nice video, thank you ! It will help me a lot ! I will change my front shocks by OEM cause I want to keep EDC working. The procedure provided by ISTA-D invite to code the EDC with ISTA-P to take the new shocks into account after installation (otherwise there is an error). I have ISTA-P but no ICOM to do it. Do you know if we can do it with INPA or WINKFP (as ISTA-P is just a graphical interface for shops to make it easy)? Thanks for your help.
@zenggelemo741
10 ай бұрын
What car shocks do you use for this version?
@bmw_e65_e66
2 жыл бұрын
Hİ GOOD WORK. ı have 2002 745i with dynımıc drive and edc . wich one ı can use pls can yoou tell me ?
@szaboimre9268
Жыл бұрын
Hi! I replaced the shock absorbers in the front, but the height of the front axle is 74 cm instead of 65.3 cm for me (2002 745i, EDC, 18 inch rims) What could be wrong?
@ecologicaltime
Жыл бұрын
if you compare the old vs new shocks were they the same size? The seat for the spring must not be flipped the other way around.
@szaboimre9268
Жыл бұрын
@@ecologicaltime Hello. There's the problem: I didn't measure well... but I don't think the shock absorbers are good. Even on a smooth road, the steering wheel shakes left and right. All swingarms and springs are new. Steering gear also replaced. Also servo oil. However, it does not shake when braking. Wheels also centered, with new continental tires, chassis adjusted.
@muckimucks8107
Жыл бұрын
you have to disable edc after putting non edc shocks in it?
@ecologicaltime
Жыл бұрын
You dont have to.
@ecologicaltime
Жыл бұрын
Check out my videos about disabling edc if you want to disable it
Пікірлер: 13