After changing the rear light, water got into the light. So I had to remove it again to fix the problem . I dried it and resealed it with bathroom silicone.
@AA-os1sg
3 жыл бұрын
If any of you ever have a problem with tail light fuse 7.5amp blowing continuously. Fuse is located drivers side under the steering wheel. Its most likely rear corroded light bulb socket. Water is known to get past the seal sits in the light casing over time & rots the plug causing a mysterious problem. Remove the light 10mm nut & reseal it. Hope my experience helps somebody! Before you call out an auto electrician. Otherwise brilliant motor!
@screwsnutsandbolts
3 жыл бұрын
Thanks for the advice :)
@victorojeda1544
Жыл бұрын
Excelent explanation , very good ,
@screwsnutsandbolts
Жыл бұрын
Thank you !
@90210dk1
3 жыл бұрын
Great video thankyou..
@screwsnutsandbolts
3 жыл бұрын
Thanks for watching ! :)
@nadim2769
3 жыл бұрын
Planning on fitting reversing sensors to mine soon so thanks, helps me out 👍🏽. But how does that one bolt hold the tail light in place? Seems insecure imo
@laniepapa8141
2 жыл бұрын
Very helpful! Thanks!!
@screwsnutsandbolts
2 жыл бұрын
You're very welcome !
@raulvibo
2 жыл бұрын
Great video! Thanks!
@screwsnutsandbolts
2 жыл бұрын
You're welcome !
@sf8055
3 ай бұрын
Ive got 2003 yaris, but the wires plug into a separate attachment to the sockets, not like this
@motorlistrikeveryday
8 ай бұрын
thank you
@screwsnutsandbolts
8 ай бұрын
You're welcome !
@huzaifabaig5522
3 ай бұрын
Bro how to remove the glass cover can u plzz tell
@takeadrive
4 жыл бұрын
Very good
@screwsnutsandbolts
4 жыл бұрын
Thanks !
@thesimplyteez
2 жыл бұрын
Is this the same procedure for the Yaris hatchback tail lights?
@screwsnutsandbolts
2 жыл бұрын
This is 2000 Yaris Hatchback.
@oscarhetakmusic
3 жыл бұрын
Would you recommend to use any sealant when putting it back to stop from leaking? If yes what kind of seal?
@screwsnutsandbolts
3 жыл бұрын
I don't think it's necessary if the rubber seal is in good condition :)
@oscarhetakmusic
3 жыл бұрын
@@screwsnutsandbolts unfortunately it isn’t in best condition. Just wondering how I could replace it
@oscarzapata7192
3 жыл бұрын
@@oscarhetakmusic any rubber type sealant like the ones u used on the transmission carter
@aidanas9890
2 жыл бұрын
I was thinking the same, my lights has accumulated about half a pint of water , which in turn had destroyed one of my bulb holder with rust. I have tipped the water out and am considered loads of bathroom silicone when the new bulb holder arrives. The existing seal is in poor condition and a section has broken off.
@jennywong8581
Жыл бұрын
How to fix horn 2011 Yaris
@screwsnutsandbolts
Жыл бұрын
I haven't worked on that model Yaris so I don't know, sorry
Пікірлер: 28