If using a different charger and cleaning your port does not help this would be the next logical step. Be sure to plug in the replacement part first to determine whether or not that will solve your problem.
@jacobdrummond3013
6 жыл бұрын
Hi. I replaced the connector on my phone, but now get "Call Failed" when making outbound calls despite my signal being absolutely fine. Inbound calls work fine too, but is this a known problem? I did try a second connector with the same result (though they were just bought cheaply off eBay rather than somewhere like IFixIt). If I disconnect the ribbon cable, the outbound calls work just fine. Before I buy a third connector, is it possible something else could be at fault?
@GoCellPhoneRepair
6 жыл бұрын
If inbound calls are working I wouldn't think that the antenna has a problem. Could be software. What happened with the first charge port?
@jacobdrummond3013
6 жыл бұрын
The original connector wore out, so it wouldn't reliably start charging without wiggling the lightning cable about (I cleaned a few times with electrical contact cleaner without a permanent solution). Given that they're inexpensive enough, I bought a third board from a different seller in the end and that now works fine. I guess its a case of not just buying the cheapest part, but then everyone on eBay lists parts as genuine or OEM when they're not so I'd say it's more look of the draw. Thanks for taking the time to reply, though. I hope my problem proves useful for someone down the line.
@mcasamassima1
8 жыл бұрын
I changed the charging port reassembling it all again I do not work as the speaker! help me!
@GoCellPhoneRepair
8 жыл бұрын
The loudspeaker? It should make contact with the two gold contacts that are on the charging port flex cable. If you mean the mic it could be misaligned or if you didn't move the rubber boot over from the original that will cause a problem for people hearing you speak.
@mcasamassima1
8 жыл бұрын
Yes the loud speaker
@GoCellPhoneRepair
8 жыл бұрын
Could be a defective port. Do you still have the old one so that you can test it? Also the contacts on the speaker itself can get bent so you may want to check them to be sure they "spring" out far enough to reach the contacts on the cable.
@mcasamassima1
8 жыл бұрын
yes, I have replaced the houses and I removed the door from the old houses and I reassembled in the new ... it may be that I ruined.I've already ordered a new door.thank you so much
@GraviScout
7 жыл бұрын
do these parts work for iphone 6s?
@GoCellPhoneRepair
7 жыл бұрын
No they are model specific. That's usually the case with iPhones outside of rare exceptions like the SE.
Пікірлер: 12