i actually insert the main line into the SMALLER end of the bobber stop. this way the swivel won’t push the stop out as I cast repeatedly. it’s just the way I do it. whatever works for you 👍🏾
@Tinygals_Tinylivin
5 жыл бұрын
Very nice video. 😁
@shawnkiesel5349
3 жыл бұрын
Nice video and set up.
@RAIDERNATION433
3 жыл бұрын
Thanks!
@PaulHVAC1
2 жыл бұрын
It appears on your setup, that the hook is free sliding through the float. So how is the float suspending the hook at a certain depth???
@RAIDERNATION433
2 жыл бұрын
The float is stopped by the swivel. The float can side free above that. Below that is the leader where the hook would be. If you want the hook to be lower you can add a weight or reel slower
@kanielakawai9624
2 жыл бұрын
how do you put water in it
@RAIDERNATION433
2 жыл бұрын
The center tube the line goes thru can be pushed out. Once pushed out, fill with how much ever water you want then be sure to push it back into place so you don't let the water out.
@jimhullak5311
Жыл бұрын
Bobber stops thick end first line.
@freddiegonz4113
Жыл бұрын
kzitem.info/news/bejne/0Zmvs6GlfIOToIY This shows the higher end water bobber
@DaveB324
2 жыл бұрын
It's line not string.
@mazerrackham5959
2 жыл бұрын
Thought that was funny 😂😂he don’t gaf
@paynecharlie4087
Ай бұрын
I'm
@paynecharlie4087
Ай бұрын
Just run line thru the the bobber ,you can use a match stick to peg it at any depth ,leave about four feet of out the bottom to tie.on bug, and you're ready.
Пікірлер: 14