Soapy water was a tool I used many times as a child when repairing pushbike tyre punctures.
@DeBaccoUniversity
2 жыл бұрын
This tip can serve many different applications and is effective;-)
@Michael-s2p3p
2 жыл бұрын
Clear presentation for beginners but flow rates should be constant from the bottle with all the control of flow handled by your CO2 controller.
@DeBaccoUniversity
2 жыл бұрын
Bottle pressure and temperature can impact flow rates which should ideally be made consistent with the regulator. Bur there are some conditions that can create some variability.
@trippewing4050
2 жыл бұрын
And just a question are you saying that with a 1400cu/ft room and the regulator set to 10 scfh it would take 10 hours or 10 minutes to reach 1200ppm?
@DeBaccoUniversity
2 жыл бұрын
With a flow rate of 10 CU.FT/HR and a room size of 1400 CU.FT the timer should be set to 10 minutes to bring your CO2 level up to 1200 PPM. See description for source and further details and descriptions... hydrobuilder.com/media/pdf/instructions/co2reg_instructions.pdf
@trippewing4050
2 жыл бұрын
Some older Titans have the bigger washer on the intake stem that the newer ones will not fit. it can be a pain finding the washer so instead ask for a replacement stem that the new co6 washer or whatever they are called will fit and it should only be around $5.
@DeBaccoUniversity
2 жыл бұрын
Thanks for sharing this cost effective correction to a potential problem.
@slookir
3 жыл бұрын
Hi, I'm new to CO2 and I want to implement it for my next crop, my growing space is 32.4 mts3, that is, 1144.195ft³. I am thinking of acquiring a 6m3 CO2 tube. I do not know if it will last for 4 months of cultivation, what do you think? also I am going to put a solenoid valve or solenoid valve together with a CO2 monitor controller. If you could guide me or give me some information on how to choose the size of the CO2 tube that I need to administer CO2 to my culture during those 4 months. or if you have information on when it is better to apply it, I could use ten thanks a lot and very good videos
@DeBaccoUniversity
3 жыл бұрын
This should help... kzitem.info/news/bejne/wIiMyIWChqWGbIo Also, if you use a compressed bottle system you can simply change bottles as needed. Point of reference for a 10,000 cubic feet growing space consumes about 50lbs of CO2 per week maintaining 1000ppm level.
@2012isRonPaul
3 жыл бұрын
what if the flask is only 200psi and what does the heater do with 120w?
@DeBaccoUniversity
3 жыл бұрын
Not sure what the question is asking...?
@2012isRonPaul
3 жыл бұрын
u no inglesh?
@محمدحسانين-ح6ن
3 жыл бұрын
How to use that in medical feild
@DeBaccoUniversity
3 жыл бұрын
This DeBacco University video may help you... kzitem.info/news/bejne/wIiMyIWChqWGbIo
@dr.trichome6419
3 жыл бұрын
👍👨🔬
@DeBaccoUniversity
3 жыл бұрын
Appreciated!
@335alien335
3 жыл бұрын
This was just confusing and poorly done. Lots of time devoted to "not exceeding 10 CFM." You do realize that these flowmeters indicate in Standard Cubic Feet per HOUR? What size warehouse would need 10 CFM? Also, what's with the totally useless timing chart?
@DeBaccoUniversity
3 жыл бұрын
CFM means Cubic Feet per Minute. CFM measures the volume of air in cubic feet for each minute it moves. In the case of an air compressor, CFM indicates how much air can move per minute. Also, the chart can provide a great starting point for those who know how to use it.
Пікірлер: 23