Learn how to set up barrier programming on Reinke Pivots by a Certified Technician from Rain for Rent.
Welcome back to another edition of Tech Talk, I'm Aaron with Rain for Rent, a Certified Reinke Technician. Today, I'd like to introduce you to one of Reinke's Manufacturing's newest panel inserts. It is the Advanced+ insert. It takes the place of the advanced panel or the pack three timer panel. A lot of the things that you will see that look familiar are Reinke's wonderful voltmeter on here. They're hour meter and also the lockable disconnect to be able to provide safety for you, the grower, and also for us, a technician once we get in working on these panels. The new format that you'll see, is a new 4.3 inch fully customizable touch screen. It allows you to be able to customize the controls of your pivot for you, the grower, to the craft that you're going to be producing. And it allows you to be able to set all of your end guns, your sectors, your second end gun and chemigation and also barricades easily through a touch format. In order to access your barrier program, you'll first tap on the top middle icon, then you'll go to programs then we'll go to barrier. And this brings us into our barrier program page. In order to enable your barriers to turn on, you must select this button and have it go to green. If it's in red, your barricades will not be enabled and they will not work on your main screen. In order to set your reverse barricade, you must touch on the blue icon below the reverse button. Enter in your degrees. Press save, go to your forward, which is the blue button blue icon below the Ford. Enter in your degrees. And that will show where your barricades are at on the main screen. If you would like to have a delay interval, enter it here on the reverse side, and it will be in the minutes. You can also go to the forward side. And from here, we want to just double check to make sure our barricades are enabled, that we have our right positioning than our delays and how we want it, and then we want to press save. Once we go there, we exit out until the main screen. We will see that our barricades have been saved and the position that we want. And in order to control them, we will use the barrier control icon here. At Auto stop, Auto stop means that both the barricades are in red and that the pivot will stop at both barricades. Auto reverse, auto reverse the barricades were shown in green, meaning that they will auto reverse at each barricade. Auto reverse auto stop means the auto reverse when system at reverse barricade and auto stop at forward barricade. And just the opposite with auto stop auto reverse auto stop the system reverse and it will auto reverse the forward barricade. Thank you for joining us for another edition of Tech Talk.
Негізгі бет How to set up Barrier Programming on Reinke Pivots by Rain for Rent
Пікірлер